Overview
The Rough Country N3 front shock R/C23191_I is a nitrogen-charged twin-tube shock for 2014–2026 Ram 2500 trucks with a 5 to 6.5 inch lift. It uses a stud at the top and an eyelet at the bottom, and it is sold as a pair.
The shock pairs a 35mm piston with an 18mm chrome-hardened piston rod inside a 54mm body. The extended length is 27.34 in and the compressed length is 16.10 in. The eyelet bottom mount is worth checking against your lift brackets before ordering, because the mount type decides which bracket fits.
Key features
- Nitrogen charged for consistent damping under load
- 10-stage variable valving across a range of speeds
- 35mm piston and 18mm chrome-hardened piston rod
- 54mm shock body designed to shed heat faster
- Rated to 36kN tensile strength
- Spring-loaded piston rod seal and rubber bushings
- Military spec damper fluid
Eyelet mounts and bushing care
An eyelet bottom mount is held by a bolt through a bushing, so the bushing is where most wear shows. Check the bushing for cracks, flattening, or looseness, and look at the bolt for proper tightness and no thread damage. A worn eyelet can rattle or allow the shock to shift under load.
The stud top mount sits at the frame bracket, and a loose nut or worn stud can add noise on rough roads. Recheck the fasteners after the first few trail runs, and check the front alignment because a lift changes the steering geometry. When you replace the shocks, use new bushings where the kit allows, and keep both fronts matched.
- Inspect the eyelet bushing
- Check stud nut tightness
- Recheck alignment after install
Specifications
| Brand | Rough Country |
|---|---|
| Part number | R/C23191_I |
| Product line | N3 Performance |
| Shock type | Twin-tube shock kit |
| Position | Front |
| Lift height | 5-6.5 in. |
| Top mount | Stud |
| Bottom mount | Eyelet |
| Extended length | 27.34 in |
| Compressed length | 16.10 in |
| Body diameter | 54mm |
| Piston | 35mm |
| Piston rod | 18mm chrome-hardened |
| Charge | Gas charged, nitrogen |
| Valving | 10-stage variable |
| Tensile strength | 36kN |
| Finish | Metallic silver paint |
| Warranty | 3-year warranty |
| Sold as | Pair |
Vehicle fitment
The shock fits the 2014–2026 Ram 2500 across its cab and trim packages. It is the front shock for that model year range with a 5 to 6.5 inch lift.
The list covers 2014–2026 Ram 2500 trucks only. Ram 1500, Ram 3500 and 2003–2013 Ram 2500 trucks are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the lift changes the front suspension height, have the alignment checked after the shocks are installed. Confirm that the top stud and eyelet bottom mount match your existing brackets.
What’s included
Sold as a pair: two N3 front shocks, one for each side. Replace both fronts together so the two shocks damp evenly.









