Overview
The Rough Country 3-inch Can-Am lift kit (part number R/C97002) is an all-aluminum lift for Can-Am Defender UTVs that gives a full 3 inches of lift from front to rear. It raises ride height and gives the machine a more aggressive look.
The kit uses a front and rear preload spacer that installs onto the factory strut, and it allows tires up to 28 inches. The spacers are aluminum and built to hold up to exposure to the elements. A Lifetime Replacement Guarantee is included.
Key features
- Full 3 inches of lift from front to rear
- Front and rear preload spacers that install onto the factory strut
- Durable all-aluminum construction
- Room for tires up to 28 inches
- Lifetime Replacement Guarantee from Rough Country
Preparing for a UTV lift
A preload spacer lift raises the vehicle by changing how the spring sits on the strut, so suspension travel and ride height change together. On a side-by-side this affects both the sway and the angle of the front and rear driveline, so the change should be planned for the whole machine. Raising the front and rear by the same amount keeps the stance balanced.
Taller tires add weight to the axles and make steering feel slower, so pair the lift with tires sized within the kit’s stated limit. Wheel offset matters too, since a change in ride height can move the tire closer to the fender. Check clearance with the suspension at full travel before going off road.
- Check strut mounts and spring seats for wear during installation
- Recheck torque on all hardware after the first few rides
- Inspect CV boots and tie rod ends when the lift changes angles
- Re-check tire clearance after any wheel change
Specifications
| Brand | Rough Country |
|---|---|
| Part number | R/C97002 |
| Lift height | 3 inches, front to rear |
| Material | Aluminum |
| Maximum tire size | 28 inches |
| Required tool | Spring compressor |
| Warranty | Lifetime Replacement Guarantee |
Vehicle fitment
The fitment covers Can-Am Defender, Defender MAX and Defender PRO models from 2016 to 2026, by HD version. Defender MAX entries run from 2017 to 2026, and the Defender PRO HD10 is covered from 2020 to 2026.
The kit does not fit Lone Star or X mr models, even though some Defender MAX entries use those names. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
A spring compressor is required for strut disassembly, so have that tool ready before you start. Lifting the front and rear changes alignment, so have it checked after installation.
What’s included
Front and rear preload spacers.
Not included: a spring compressor, which the installation requires.















