Overview
The RockJock Rear Coil Spring Retainer Kit (part number CE-9807RRK) is a rear-only kit for the 2007–2018 Jeep Wrangler JK, in both 2-door and 4-door models. It holds the rear coil springs in place so they do not pop out during off-road travel.
The kit includes everything needed to clamp the top of each coil to the frame and the bottom of each spring to the axle housing. It is sold as one set for both sides of the rear.
Key features
- Keeps the rear coil springs from popping out off-road
- Clamps the top of the spring to the frame
- Clamps the bottom of the spring to the axle housing
- Includes hardware for both sides
- Rear position only
Keeping the rear springs seated
Rear coil springs sit in upper and lower seats, and retainers keep them from shifting out when the axle articulates on rough trails. Most spring movement happens on steep climbs and drops, when one wheel lifts and the axle twists. A clamp that is loose or misaligned lets the coil walk off its seat, so the fit should be checked after each trail outing.
Choosing a retainer kit comes down to fit for your model and a clean fit with the rest of the rear suspension. A lift, longer shocks or heavier tires can change how the spring loads, so re-inspection is worthwhile after any suspension change. Replacing worn spring isolators or bump stops alongside the retainers is a common step.
- Inspect the spring seats for cracks or wear
- Retighten clamp hardware after the first trail runs
- Check that each spring sits centered in its seat
Specifications
| Brand | RockJock 4×4 |
|---|---|
| Part number | CE-9807RRK |
| Position | Rear |
| Quantity | One set, both sides |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler (JK) 2-door and Unlimited 4-door models, including the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X versions.
The front axle, the JL, and the LJ and TJ generations are not covered by this part. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Retainers hold the coil in place at the frame and axle, so the springs and clamps must be fitted to the correct side of the rear. Check the brake lines and the driveline after the kit is installed.
What’s included
The retainer clamps and hardware for both rear springs.










