Overview
The RockJock 4×4 CE-9114L-22 is a forged Johnny Joint rod end, part number R/JCE-9114L-22, with a 1 1/4″-12 left hand threaded shank. It comes fully assembled with RockJock’s standard Johnny Joint internals.
The internals are a 2.812 inch wide ball center with a .750 inch thru bolt hole. The joint is externally greasable through a zerk and finished in gold zinc plating.
Key features
- Forged steel construction
- 1 1/4″-12 left hand threaded shank
- Standard internals with 2.812″ wide ball center
- .750″ thru bolt hole
- Externally greasable via zerk
- Gold zinc plating finish
- Matching jam nuts mentioned by RockJock
Left hand threads and installation
Left hand threads run opposite to the usual right hand threads, so the joint tightens by turning counterclockwise when viewed from the threaded end. Mixing up threads is a common mistake when rebuilding linkage, and it can seize or strip a sleeve. Before threading, mark the sleeve or link so you can confirm the hand of each side during assembly.
Assemble the joint fully, then set the length and tighten the locknut once the joint is centered. Grease the zerk after assembly so the bearing surfaces are protected from the start. Check the bolt hole fit and the clearance at full travel, and inspect the threads after the first few trail runs, since fresh assemblies often settle under load.
- Confirm thread hand on both sides
- Grease the zerk after assembly
- Check bolt hole fit and full-travel clearance
Specifications
| Brand | RockJock 4×4 |
|---|---|
| Part number | R/JCE-9114L-22 |
| Joint type | Forged Johnny Joint rod end |
| Shank thread | 1 1/4″-12 left hand |
| Ball center | 2.812″ wide |
| Thru bolt hole | .750″ |
| Material | Forged steel |
| Finish | Gold zinc plating |
| Lubrication | Externally greasable, zerk fitting |
| Assembly | Fully assembled |
Vehicle fitment
It is a universal fit, so it is not tied to one vehicle. Confirm the 1 1/4-12 left hand thread and .750 inch bolt hole against your links and brackets before installing.
No vehicle year, model or chassis is named for this joint.
Installation notes
Grease the joint through its zerk after assembly. Because the thread is left hand, confirm the thread direction on the link or sleeve you are threading it into.
What’s included
One fully assembled forged Johnny Joint rod end.
Not included: Jam nuts are not included with the joint.









