Overview
The passenger side Rock Slide Engineering Step Slider, part number RSEBD-SS-200-JL4P, is a powered rock slider and entry step for the Jeep Wrangler JL. It fits the 2018–2026 Wrangler JL Unlimited four-door trims, from the 80th Anniversary edition through the Willys Sport.
The unit is built from eleven gauge steel with stainless steel internals and finished in textured black powder coat. When the passenger door opens, the step lowers a full twelve inches from the slider body, then retracts flush once the door closes. It is rated for typical off-road use.
Key features
- Powered step that lowers a full twelve inches from the slider body.
- Retracts flush with the slider after the door closes.
- Eleven gauge steel body.
- Stainless steel internals.
- Flexible thermo-plastic base with a textured black top coat.
- Uses existing body and frame holes and bolt locations for mounting.
- Stand-alone wire harness with no splicing into the Jeep’s wiring.
- Rated for typical off-road conditions up to a level 4-5 type trail.
Before a trail day
Preparation helps a powered step last. Before a trip, cycle the step a few times to confirm it deploys and retracts smoothly, and look for debris around the hinge. Check that the mounting fasteners are snug and that the harness is secured away from moving parts and sharp edges.
A JL carries a lot of weight in its body, so the rock slider and step take impact on steep, rocky ground. Keep loose gear out of the door area that could catch the step, and keep recovery straps clear of the slider. If you add a skid plate or other underbody protection, confirm it does not interfere with the step’s travel.
- Cycle the step before leaving
- Secure harness runs away from moving parts
- Keep loose gear out of the door swing
- Recheck fasteners after the first rough trail
Specifications
| Brand | Rock Slide Engineering |
|---|---|
| Part number | RSEBD-SS-200-JL4P |
| Product type | Rock slider with powered step, passenger side |
| Steel gauge | Eleven gauge |
| Internals | Stainless steel |
| Finish | Textured black top coat over a flexible thermo-plastic base |
| Step travel | A full twelve inches from the slider body |
| Off-road rating | Typical off-road conditions up to a level 4-5 type trail |
| Wiring | Stand-alone wire harness |
| Installation type | No drill |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2018–2026 Jeep Wrangler JL Unlimited four-door trims: 80th Anniversary, Freedom, High Altitude, Islander, Moab, Rubicon, Rubicon 392, Sahara, Sahara Altitude, Sport, Sport Altitude, Sport S, Willys and Willys Sport. Two-door JL models and earlier generations are not covered, so check your year, model and trim against this fit before buying.
Two-door Wrangler JL models and Wrangler JK and earlier generations are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Work with the battery disconnected while you attach the powered step’s harness. The mounts fasten to holes and bolt points already present on the body and frame.
What’s included
A complete set includes a micro processor, a stand-alone harness and the hardware needed to bolt the sliders on. Confirm the items on arrival match your installation plan before starting.
Not included: The driver side step slider and the skid plate for more aggressive trails.











