Overview
The passenger side Rock Slide Engineering Step Slider, part number RSEBD-SS-200-JK4P, is a powered rock slider with an entry step for the Jeep Wrangler JK. It fits the 2007–2018 Wrangler JK Unlimited four-door models, including Rubicon, Sahara, Sport and Sport S trims. The design is patented.
Its eleven gauge steel body and stainless steel internals carry a textured black powder coat. The step opens a full twelve inches below the slider when the passenger door swings open and folds back flush once the door shuts. The slider is offered in 2-door and 4-door versions.
Key features
- Passenger side unit, sold as one half of the pair.
- Step extends a full twelve inches from the slider body when the door opens.
- Eleven gauge steel body.
- Stainless steel internals.
- Flexible thermo-plastic base coat under a textured black top coat.
- Mounts to existing body and frame holes and bolt locations.
- Stand-alone wire harness that avoids splicing into the Jeep’s electronics.
- Rated for typical off-road conditions up to a level 4-5 type trail.
Keeping the step working
Powered steps mix a mechanical hinge with an electrical motor, so both parts need checking on a regular basis. After trail runs, clear mud and grit from the step track and hinge area, and look for debris that could slow the motion. A step that drags, stops short or moves unevenly is worth inspecting before it gets worse.
The lower body of a Jeep takes most of the impact from rocks and ledges, so the slider and its mounting points carry real load. Recheck fasteners after rough trips, and watch the body holes for cracking or elongation. If you run larger tires or add a lift, confirm the step still clears its full travel and the passenger door opens without interference.
- Clean the step track after muddy trips
- Inspect mounts and bolt points for looseness
- Watch the harness for chafing near sharp edges
- Confirm the door opens fully with the step deployed
Specifications
| Brand | Rock Slide Engineering |
|---|---|
| Part number | RSEBD-SS-200-JK4P |
| Product type | Rock slider with powered step, passenger side |
| Steel gauge | Eleven gauge |
| Internals | Stainless steel |
| Coating | Thermo-plastic base with textured black top coat |
| Step travel | A full twelve inches from the slider body |
| Off-road rating | Typical off-road conditions up to a level 4-5 type trail |
| Wiring | Stand-alone wire harness |
| Installation type | No drill |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler JK Unlimited four-door models in Rubicon, Sahara, Sport and Sport S trims. Two-door JK models and the Wrangler JL are not covered, so confirm your year, model and trim against the fit list first.
Two-door JK models and the Wrangler JL are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The mounts fit into holes and bolt points that already exist on the body and frame, so no new holes are needed. The stand-alone harness is the only electrical connection for the powered step.
What’s included
A complete set includes a micro processor, a stand-alone harness and the hardware needed to bolt the sliders on. Confirm the items on arrival match your installation plan before starting.
Not included: The driver side step slider and the additional skid plate for more aggressive trails.











