Overview
The Rock Slide Engineering 3rd Generation Step Slider, part number RSEBD-SS-300-JL4, is a powered rock slider with an entry step for the 2018–2026 Jeep Wrangler JL. It fits four-door Unlimited models, from the 80th Anniversary edition through the Willys Sport.
The curved step follows the body contour and adds 2 inches at the rear for easier access to the rear door. The motor has no gas strut, and a sleep mode limits battery drain. The step deploys 12 inches down when the door opens and retracts flush after the door closes.
Key features
- Powered step that deploys 12 inches down when the door opens.
- Curved contour that narrows the gap between the extension and the fender flare.
- Additional 2 inches at the back end of the step.
- Smart motor technology with the gas strut removed for longer motor life.
- Sleep mode to minimize battery drainage.
- Stainless steel and aluminum internals to prevent rusting.
- Stand-alone wire harness, so no splicing or rewiring is needed.
- Factory mounting points used for a no-drill installation.
Powered steps on the trail
A powered step adds a moving part to a rock slider, so it earns a look before and after each trip. Clear mud, sand and small rocks from the step track and hinge area, since packed debris is the most common reason a motorized step slows. Watch for a step that stops short of full travel or moves unevenly, which can point to a binding joint or a harness connection that needs attention.
Powered steps are often run alongside other body protection, such as skid plates, so the lower body stays covered on rough routes. Before adding accessories, check that they clear the step’s full travel and do not block the rear door from opening fully. A wider rear step also changes how the door swings, so keep the door check and hinges in good shape.
- Rinse the step track after muddy trips
- Look over harness connectors for chafing
- Confirm the step returns fully flush after each cycle
Specifications
| Brand | Rock Slide Engineering |
|---|---|
| Part number | RSEBD-SS-300-JL4 |
| Product type | Rock slider with powered step (3rd Generation Step Slider) |
| Body material | 10-gauge steel construction |
| Internals | Stainless steel and aluminum |
| Finish | Black |
| Length | Cab |
| Step deployment | 12 inches down from the slider body |
| Rear extension | 2 inches added to the back end of the step |
| Off-road rating | Moderate off-road conditions |
| Wiring | Stand-alone wire harness |
| Installation type | No cutting or drilling required |
| Fitment type | Direct fit |
Vehicle fitment
The manufacturer fitment list covers the 2018–2026 Jeep Wrangler (JL) Unlimited four-door trims: 80th Anniversary, Freedom, High Altitude, Islander, Moab, Rubicon, Rubicon 392, Sahara, Sahara Altitude, Sport, Sport Altitude, Sport S, Willys and Willys Sport.
Two-door Wrangler JL models and earlier Wrangler generations are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The stand-alone harness is plug and play and connects without splicing into the Jeep’s wiring. Mounting uses the factory points, so no drilling is needed.
What’s included
The step slider comes with its stand-alone wire harness. Confirm the contents on arrival match your installation plan, including whether one or both sides are included.


















