Overview
The Rock Slide Engineering driver side Step Slider (part number RSEBD-SS-200-JK4D) is a trail rated rock slider with a powered step for the Jeep Wrangler JK. It protects the lower body of the vehicle from trail damage and fits the 2007–2018 Jeep Wrangler JK Unlimited 4-door trims.
When the driver door opens, the step deploys a full twelve inches down from the slider body, giving a lower entry point. When the door closes, the step retracts flush with the slider body. The design is patented, and the slider is offered in 2-door and 4-door versions.
Key features
- Powered step deploys twelve inches down when the door opens and retracts flush when the door closes.
- Eleven gauge steel construction with stainless steel internals.
- Maintenance free powder coating with a flexible thermo-plastic base coat and a textured black top coat.
- No-drill installation that reuses pre-existing body, frame and bolt locations.
- Rated for typical off-road conditions up to a level 4-5 type trail.
- Stand alone wire harness, so the vehicle’s electronics do not need to be spliced.
Caring for a steel rock slider
A rock slider takes hits from rock and ground contact, so the protective coating and the steel beneath it both need regular attention. Wash off mud and grit after trail use, then look for chips in the textured top coat. Small chips left alone can let moisture reach the base coat, so touch them up before they spread.
Powered steps add a moving part to the lower body, and the mounting points carry the load of each trail hit. Recheck fasteners after the first few outings, then at intervals. A slider that shifts or rattles usually points to a loose mount, and tightening it early prevents wear on the body holes.
- Wash the slider after muddy or salty trips
- Touch up chips in the coating promptly
- Check the step returns fully flush after each cycle
- Keep skid plate fasteners tight on aggressive trails
Specifications
| Brand | Rock Slide Engineering |
|---|---|
| Part number | RSEBD-SS-200-JK4D |
| Position | Driver side |
| Body material | Eleven gauge steel |
| Internals | Stainless steel |
| Finish | Maintenance free powder coating: flexible thermo-plastic base coat, textured black top coat |
| Step travel | Twelve inches down from the slider body |
| Trail rating | Typical off-road conditions up to a level 4-5 type trail |
| Versions | 2 door and 4 door |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler (JK) in the Unlimited Rubicon, Sahara, Sport and Sport S trims, all 4-door.
Two-door Wrangler JK models are not covered by this fit, and other Wrangler generations do not fit this step slider. Match your year, model and trim to the fit list before ordering.
Installation notes
Installation is no-drill. The step slider mounts to existing body and frame holes and bolt locations, and the stand alone wire harness avoids splicing into the electronics. For more aggressive trails, an additional skid plate adds stability and protection to the step and vehicle.
What’s included
A complete set includes driver and passenger side step sliders, a stand alone wire harness, a micro processor and all hardware needed to bolt them to the Jeep body. This item is the driver side unit only.
Not included: the passenger side step slider, since this item is the driver side unit, and the additional skid plate recommended for more aggressive trails.











