Overview
The Rock Krawler RK05016 is a weld-on rear cradle kit for the 2004–2006 Jeep Wrangler LJ and the 1997–2006 Jeep Wrangler TJ. It is laser cut from 1/4 inch thick steel and is intended for the rear axle location.
The cradle is a durable black powder coated part made in the U.S.A. It covers the LJ Unlimited and Unlimited Rubicon and the TJ 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
Key features
- 1/4 inch plate steel construction
- Laser cut steel
- Durable black powder coat finish
- Made in the U.S.A.
- Abuse proof lifetime warranty
- Rear axle location, without steering ram mount
Welding and finishing the cradle
A weld-on cradle is only as good as its welds. Clean the mating surfaces of paint, rust and mill scale, then dry fit the cradle before tacking it into place. Check that the cradle sits square to the frame and that the axle location is correct before running final welds.
Plan the finish before welding. Heat from welding can burn off coatings near the joint, so touch up the bare areas after welding and before final assembly. A black powder coat resists road debris well, but it should be inspected at the welds and any bolted points after the first trail runs.
- Clean all contact surfaces before fitting
- Dry fit and check squareness before welding
- Touch up bare metal near the welds
- Inspect welds after the first trail runs
Specifications
| Brand | Rock Krawler |
|---|---|
| Part number | RK05016 |
| UPC | 700007685751 |
| Material | 1/4 inch plate steel |
| Finish | Black powder coat |
| Axle location | Rear axle |
| Axle type | Universal |
| Steering ram mount | Without steering ram mount |
| Mounting method | Weld on |
| Warranty | Abuse proof lifetime warranty |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler (LJ), including Unlimited and Unlimited Rubicon trims, and the 1997–2006 Jeep Wrangler (TJ), including 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
Other Wrangler generations are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
This is a weld-on part, so welding is required and it is not a bolt-on installation. Disconnect the battery before welding near the wiring.
What’s included
The kit is a rear cradle made from 1/4 inch plate steel with a black powder coat finish.
Not included: welding equipment, which the weld-on installation requires.




