Overview
The Redarc GS-AMPS (part number RAEGS-AMPS) is a hall effect current sensor. It measures the current flowing in a circuit and outputs that value as a voltage signal, so it can monitor the current to or from your main or auxiliary battery. It is an optional sensor for the REDARC G52-VVA and G52-VA battery gauges.
This high performance sensor is compact and mounts directly on the cable it measures. It is fully sealed for rugged installations. It cannot be damaged by overload.
With a REDARC gauge, the sensor adds current readings alongside the gauge display. If there is an alternator or system failure, the gauge voltage reading falls as the battery discharges. In an overcharge condition the gauge climbs above its normal zone. Pre-set alert levels change the gauge backlight to programmable amber or red.
Key features
- Hall effect design that outputs the measured current as a voltage signal
- Monitors current to or from the main or auxiliary battery
- Compact, cable mounted body for rugged environments
- Suited to installations where a fully sealed product is required
- 100A rated and cannot be damaged by overload.
- Optional sensor for the REDARC G52-VVA and G52-VA gauges
Choosing a current sensor setup
A current sensor sits in the battery circuit and reports how much current moves to or from the battery. That reading helps show whether charging keeps pace with the loads you run, such as lights, fridges, compressors and winches. Because the sensor feeds a gauge, its value depends on the gauge it connects to, so match the two before buying.
Cable mounting means the sensor clamps onto a conductor that already carries the current. Choose a route where it sits without strain, away from heat sources and moving parts. During routine checks, look at the sensor and its connections for chafed insulation, loose terminals or corrosion near the battery end. A sealed body helps in wet or dusty conditions, but it does not replace careful wire routing.
- Confirm the gauge model before adding the sensor
- Keep the sensor clear of moving parts and heat
- Inspect the battery end connection at each service
Specifications
| Brand | Redarc |
|---|---|
| Part number | RAEGS-AMPS |
| Product type | Hall effect current sensor (GS-AMPS) |
| Current rating | 100A |
| Output | Voltage signal representing the measured current |
| Mounting | Cable mounted |
| Compatible gauges | REDARC G52-VVA and G52-VA |
Vehicle fitment
This sensor is not vehicle-specific. It is an electrical accessory for battery current monitoring and is not matched to a year, make, model or trim. Its use depends on the REDARC gauge it connects to.
Confirm which REDARC gauge you use before ordering. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Follow the REDARC instructions to connect the sensor, and use fused wiring on the battery connection.
What’s included
The gauge is a separate product, and this sensor is an option for the G52-VVA and G52-VA. Confirm the included parts against your installation plan before starting.









