Overview
The Daystar Firewall Boot KU20041BK, part number DAYKU20041BK, is a boot for passing wires, hoses and other lines through a vehicle firewall. Daystar presents it as an alternative to leaky rubber grommets. The Universal Fit tag is the only fitment statement, with no make, model or year named.
Key features
- Installs in a 1.25 inch diameter hole drilled in the firewall
- Boot can be trimmed to suit the lines passing through it
- Assembly is secured with a zip tie
- Designed to route wires, hoses and other lines
Sealing and protecting the firewall pass-through
A firewall pass-through has to handle more than routing. The engine bay side of the firewall gets hot, sees road spray and moves with engine vibration, so the opening should be clean, deburred and free of sharp edges before the boot goes in. Wires and hoses rubbing against a rough edge are a common cause of chafing, which is why routing them so they rest on the boot rather than the metal matters.
Before drilling, confirm what sits behind the firewall at the spot you plan to use. Brake lines, fuel lines, wiring harnesses and heater hoses often run close together, and a drill bit can go through more than the panel. Once the boot is in, check that the lines pass through without being stretched or bent sharply. Re-check the boot and zip tie after the first few drives, since vibration can loosen the fit over time.
- Deburr the hole edge before fitting
- Leave slack in lines so they do not pull at the boot
- Keep heat sources away from plastic and rubber parts
- Inspect the boot for cracks or gaps at each service
Specifications
| Brand | Daystar |
|---|---|
| Part number | DAYKU20041BK |
| Model | KU20041BK |
| Hole size | 1.25 inch diameter |
| Securing method | Zip tie |
Vehicle fitment
Fitment is not matched to any vehicle, so the boot is not tied to a make, model or year. Measure your firewall opening and the bundle of lines you plan to route before buying.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Drill a 1.25 inch diameter hole in the firewall, install the boot, run the wires or lines through, trim the boot as necessary and secure the assembly with a zip tie. Check the far side of the firewall for wiring and components before drilling.
What’s included
The firewall boot is the item described.
Not included: Have zip ties on hand to secure the assembly before starting.









