Overview
The REDARC 30A Circuit Breaker Kit, model CBK30-EB and part number RAECBK30-EB, provides wiring and connections for a three-axle electric trailer brake controller setup. It is not tied to a specific vehicle.
Much of the wiring work is already done. The battery connection wire has a protective conduit, heat shrink and a crimp attached, and the brake controller connection is pre-crimped with heat shrink. A protective boot covers the circuit breaker and guards against accidental terminal shorts.
Key features
- Battery connection wire with protective conduit, heat shrink and crimp already attached
- Brake controller connection pre-crimped with heat shrink
- Protective boot for the circuit breaker
- Detailed wiring diagram included
- Nuts provided for attaching both wires to the breaker
Trailer brake wiring basics
A circuit breaker protects the trailer brake wiring from overload and from short circuits. Its rating should match the wire gauge and the controller’s output, so the breaker trips before a wire overheats. Route the wiring away from hot exhaust parts, moving suspension components and sharp edges, and secure it with clips so it cannot chafe.
Good trailer brake wiring depends on solid connections and a clean ground. Crimped joints should be pulled on to confirm they hold, and the breaker should sit where it stays dry. After installation, test the brake output with the trailer connected and confirm the breaker resets properly.
- Keep the breaker dry and accessible
- Route wires away from heat and sharp edges
- Recheck nuts and crimps after the first trips
Specifications
| Brand | Redarc |
|---|---|
| Part number | RAECBK30-EB |
| Model | CBK30-EB |
| Circuit breaker rating | 30A |
| Application | Three-axle electric trailer brake controller setup |
| Included | Wiring diagram, protective boot, nuts |
| Fit type |
Vehicle fitment
This kit is not vehicle-specific, and no vehicle is named. It is built for a trailer brake controller wiring arrangement with three axles, so confirm the trailer’s axle count and controller match before wiring.
Installation notes
Attach both wires to the circuit breaker with the nuts provided. REDARC recommends soldering the brake controller joint after crimping to ensure a positive electrical connection. Keep the protective boot in place over the breaker once the connections are made.
What’s included
The kit includes the battery and brake controller wires, the circuit breaker nuts, the protective boot and the wiring diagram.
Not included: the electric trailer brake controller that the wiring connects to.



















