Overview
The Redarc G52-VA (part number RAEG52-VA) is a single voltage 52mm gauge that shows battery voltage and sends alerts when the voltage moves out of range. An optional 100A current display is available, and it requires the REDARC Hall Effect Current Sensor (GS-AMPS), sold separately. It is not matched to one vehicle. The sections below cover the battery and ignition voltages it works with.
If there is an alternator or system failure, the voltage reading falls and drops as the battery discharges. In an overcharge condition the gauge climbs above its normal zone. Pre-set alert levels (16V) notify you of these changes by changing the backlight to amber or red, and the G52-VA also beeps when the vehicle ignition is on. The display illuminates with park lights turned on, so you can check battery health without turning on the ignition.
Key features
- Single voltage display for monitoring battery health
- Alerts when battery voltage drops below 9V or climbs above 16V
- Backlight changes to amber or red at pre-set alert levels
- Beeps when the vehicle ignition is on
- Satin chrome bezel with 13 backlight color options
- Optional 100A current display using the GS-AMPS sensor
Reading battery voltage alerts
A battery voltage gauge gives an early look at how the battery and charging system are doing. A reading that sags under load or stays low after driving can point to a weak battery, a failing alternator or a poor connection. Voltage that climbs above the normal range can signal a regulator fault, which stresses both the battery and electronics. The alerts are a prompt to investigate, not a diagnosis.
Before relying on the gauge, confirm the sensing wire is connected at a clean, fused point. Loose ground connections often show up as odd readings, so inspect them along with the gauge wiring. Backlight color helps at a glance, but a meter check at the battery is the reliable way to confirm a problem.
- Check battery terminals and ground connections first
- Recheck the reading after a drive
- Confirm readings with a meter before replacing parts
Specifications
| Brand | Redarc |
|---|---|
| Part number | RAEG52-VA |
| Gauge size | 52mm |
| Display | Single voltage, with optional current display |
| Low voltage alert | Below 9V |
| High voltage alert | Above 16V |
| Current display rating | 100A (requires the GS-AMPS sensor) |
| Bezel | Satin chrome |
| Backlight | 13 color options |
Vehicle fitment
The gauge can be connected to a 12 volt battery system and, through an adaptor, to a vehicle with a 24 volt ignition. Match the battery and ignition voltage to your vehicle before connecting.
Only a 12 volt battery can be monitored, even when the 24 volt adaptor is used. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
To run the G52-VA on a 24 volt ignition, use the REDARC 24 to 12 Volt Adaptor (GA-2412V). The adaptor does not allow a 24 volt battery to be monitored. For the current display, add the GS-AMPS sensor, which is rated 100A. Use fused wiring on the gauge circuit.
What’s included
The gauge does not include the GS-AMPS current sensor or the GA-2412V adaptor. Not included: the GS-AMPS current sensor, which the current display needs, and the GA-2412V adaptor, which is needed only for a 24 volt ignition.









