Overview
The Rancho RS55064 is a rear shock absorber from the RS5000X Series, fitting the 2018 Jeep Wrangler (JL), including Rubicon, Sport and Unlimited trims. It is a direct fit with 0 in. lift/drop, making it a replacement rear shock rather than a lift part.
The body is an enlarged 2-1/4 inch twin tube with a full-displaced 35mm bore, a 16mm nitro-carburized rod and a 1-3/8 inch sintered iron piston. The gas pressurized body and tuned compression control valve belong to the same design.
Key features
- Progressive engagement valving
- Tuned compression control valve
- Rebound bumper
- Gas pressurized body with an enlarged 2-1/4 inch twin tube
- Glass-filled, Fluon banded piston
- Low-friction, self-lubricating seal
- Protective boot and double-welded loops
Rear shock replacement basics
A rear shock on a Wrangler handles rebound after the axle moves over bumps, so its valving has a direct effect on how the back end settles. A worn rear shock can let the vehicle bounce or wander on washboard roads, and the change is often gradual enough that owners do not notice it until the ride has deteriorated.
Replacing a rear shock is usually a straightforward job, but the old mounts should be checked for cracked rubber and loose hardware. Fresh bushings and bolts make the new unit perform as intended, and they prevent the shock from being pulled out of alignment during installation.
- Look for leaking fluid on the body
- Check mount bushings for cracks or softening
- Tighten fasteners once the vehicle is back on the ground
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS55064 |
| UPC | 39703009393 |
| Line | RS5000X Series |
| Position | Rear |
| Fitment type | Direct fit |
| Lift/drop | 0 in. lift/drop |
| Compressed length | 17.24 |
| Extended length | 24.41 |
| Travel length | 7.17 |
| Body | 2-1/4 inch twin tube |
| Bore | Full-displaced 35mm |
| Rod | 16mm nitro-carburized |
| Piston | 1-3/8 inch sintered iron |
| Bushings | Black natural rubber |
| Hydraulic / gas charged | Gas charged |
Vehicle fitment
It fits the 2018 Jeep Wrangler (JL) in the Rubicon, Sport, Sport S, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport and Unlimited Sport S trims.
The fitment entry covers only the 2018 Wrangler JL, so the earlier JK generation and the Gladiator are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The package is one rear shock absorber. Check the package contents, including any mounting hardware, against your installation before starting.









