Overview
The Rancho RS5111 is a front gas-charged shock absorber in the RS5000 Series, with a lift rating of w/0 – 2 in. Lift. No vehicle fitment is available for this part number, so confirm fit for your vehicle’s year, model and trim before ordering.
The RS5111 uses ten-stage velocity sensitive valving, a 5/8-in. (16mm) piston rod and a 1 3/8-in. (35mm) piston. The RS5000 Series is built for both stock-height and raised vehicles.
Key features
- Front position, gas-charged design
- Lift rating w/0 – 2 in. Lift
- Ten-stage velocity sensitive valving
- 5/8-in. (16mm) diameter piston rod
- 1 3/8-in. (35mm) diameter piston
- Red protective boot included
Choosing the right shock height
A shock absorber works best when its lift rating matches the height of the suspension it is mounted to. Measure your current ride height at each corner before choosing a front shock, and compare it with the w/0 – 2 in. Lift range. A shock rated for a lower lift can bottom out or run with too little travel on a raised truck, while one that is too long for a stock suspension can strain the mounts.
Damping behavior also depends on the rest of the suspension. Front shocks are often replaced alongside worn bushings, ball joints and springs, because a loose front end will wear a new shock quickly. If the vehicle is being raised, consider whether the springs, control arms and steering components are rated for the new height before finalizing the setup.
- Measure ride height before ordering
- Replace shocks in pairs to keep handling even
- Inspect bushings and mounting hardware at the same time
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS5111 |
| UPC | 39703511100 |
| Series | RS5000 Series |
| Position | Front |
| Charge | Gas charged |
| Valving | Ten-stage, velocity sensitive |
| Piston rod diameter | 5/8 in. (16 mm) |
| Piston diameter | 1 3/8 in. (35 mm) |
| Lift rating | w/0 – 2 in. Lift |
| Fitment type | Direct fit |
| Warranty | Limited lifetime (Rancho) |
| Quantity | Each |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before ordering. Match the w/0 – 2 in. Lift rating to your suspension height first.
Because no vehicles are named, match the w/0 – 2 in. Lift rating to your suspension height first. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The listed lift rating spans 0 to 2 in., which suits stock-height trucks through lightly lifted ones. Confirm that rating matches your suspension height before fitting.
What’s included
Supplied: one RS5111 front shock; a red protective boot is included.









