Overview
The Rancho RS44062 is a front 2.5 inch leaf spring for 1959 to 1975 Jeep CJ5 and CJ6 vehicles, the CJ6A from 1966 to 1968, and Willys CJ-5 and CJ-6 models from 1955 to 1958. It is sold as a single spring, and two are required to lift both front corners.
A leaf spring carries part of the front axle load and sets how high the body rides above the axle. This spring is rated for a lift height range of 0 to 4.99 inches. Rubber bushings come with each spring, and it is a direct-fit replacement for the Jeep models covered below.
Key features
- Presets set to reduce settling over time, which Rancho says also helps service life
- Leaf ends are trimmed to reduce friction and spread stress more evenly
- Individual leaves are shot-peened to reduce stress and improve fatigue life
- Rubber bushings included with each spring
- Front position, direct-fit replacement
- Covered by a Rancho limited lifetime warranty
Matched pairs and front suspension
Front leaf springs share the load between the frame and axle, so a matched pair keeps the front end level. Install both springs at the same time and check that the axle sits square under the frame. A single new spring beside an older, sagged one can pull the body to one side and throw off steering.
Lifting the front changes the angles at the driveshaft, steering and track bar. Check the U-joint angles after installation, and plan for a steering alignment. Shock absorbers may need to be longer or re-valved to match the new ride height.
Inspect the spring pack, shackles and bushings at each service. Look for cracked or broken leaves, sagging, and metal rubbing on the spring clips. Replacing worn shackles and bushings when the springs are changed keeps the new pair riding evenly.
- Replace both front springs at the same time
- Check U-joint angles after the lift
- Inspect shackles and bushings for wear
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS44062 |
| UPC | 39703440622 |
| Position | Front |
| Spring quantity | Single spring; 2 required |
| Lift height range | 0 to 4.99 inches |
| Bushings | Rubber bushings included |
| Fitment type | Direct fit |
| Sold | Individually |
| Warranty | Limited lifetime (Rancho) |
Vehicle fitment
Rancho’s manufacturer fitment list for the RS44062 covers these vehicles:
- 1959–1975 Jeep CJ5 (Base, Renegade)
- 1959–1975 Jeep CJ6 (Base)
- 1966–1968 Jeep CJ6A (Base)
- 1955–1958 Jeep Willys CJ-5
- 1956–1958 Jeep Willys CJ-6
Vehicles from 1976 onward, including the CJ7 and the Scrambler, are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Install both front springs as a matched pair so the left and right heights stay even. Because the springs are preset, replacing only one side can leave the front end uneven. Lifting the front end changes driveline angles and steering geometry, so have an alignment and driveline check done after installation.
What’s included
One front leaf spring with rubber bushings.
Not included: the second front spring, since it is sold individually and two are required.







