Overview
The Rancho RS44162 is a rear 2.5 inch leaf spring for Jeep CJ5 and CJ6 vehicles from 1959 to 1975. It also fits the CJ6A from 1966 to 1968 and Willys CJ-5 and CJ-6 models from 1955 to 1958. It is sold as a single spring, and two are needed to lift both rear sides.
Rear leaf springs locate the axle and carry a large share of the rear load, so the two sides should be replaced together. The lift height range is 0 to 4.99 inches. Rubber bushings come with the spring, and it is a direct fit.
Key features
- Rear position, sold as one spring with two needed per vehicle
- Rubber bushings included
- Presets help limit settling and extend the spring’s working life.
- Leaf ends trimmed for lower friction and steadier stress distribution
- Each leaf is shot-peened, a process Rancho uses to relieve surface stress
- Rancho limited lifetime warranty applies
Rear pinion angle after a lift
Raising the rear end changes the pinion angle, which is the angle the driveshaft meets the axle. When that angle moves too far from the transmission output angle, the u-joints wear quickly and can vibrate at speed. A pinion angle check is a practical step after any spring change on a CJ, and it is one reason the rear end should be looked at after installation.
Old CJ springs often lose height on one side first, so inspect both shackles, shackle bolts and bump stops before fitting the new pair. Replacing the springs in matched pairs keeps the axle square, and a rear end that sits level is easier to align and steers more predictably on the road.
- Measure pinion angle before and after fitting
- Check u-joints for play or vibration
- Inspect shackles and bump stops
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS44162 |
| UPC | 39703441629 |
| Position | Rear |
| Spring quantity | Single spring; 2 needed |
| Lift height range | 0 to 4.99 inches |
| Bushings | Rubber bushings included |
| Fitment type | Direct fit |
| Sold | Individually |
| Warranty | Limited lifetime (Rancho) |
Vehicle fitment
The RS44162 fits these vehicles:
- 1959–1975 Jeep CJ5 (Base, Renegade)
- 1959–1975 Jeep CJ6 (Base)
- 1966–1968 Jeep CJ6A (Base)
- 1955–1958 Jeep Willys CJ-5
- 1956–1958 Jeep Willys CJ-6
Later 1976 and newer CJ-series models are not in this list, including the CJ7 and Scrambler. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replace both rear springs together so the axle sits level and the springs carry equal load. After a lift, the rear pinion angle changes, so check driveline angles and have the rear end inspected after installation. Rubber bushings are supplied, so confirm the old bushings are removed before fitting the new set.
What’s included
One rear leaf spring with rubber bushings.
Not included: the second rear spring, which is needed because this spring is supplied one at a time.






