Overview
The Omix-ADA 18202.02 is a factory-style 9 leaf rear replacement spring for early Willys and Jeep CJ models. It is a stock height direct replacement, so it returns the original rear height without adding lift.
It fits the 1955–1958 Willys CJ-5 and CJ-6 and the 1959–1960 and 1966–1975 Jeep CJ5 and CJ6. Bushings are not included.
Key features
- Nine leaf rear spring pack
- Factory-style design built as a replacement
- Stock height with no added lift
- Bushings not included
- Covers the CJ5 and CJ6 years listed below
Rear springs on older CJs
The rear spring on an early CJ carries the axle and the bulk of the load in the back. As it sags, the rear end sits lower, the axle can shift under braking, and the ride gets rough over bumps. Restoring stock height brings the rear geometry back closer to the original design.
Rear springs are often replaced with the shackles, bolts and spring pads at the same time. Worn shackle bushings let the spring move unevenly, so inspect them while the axle is supported. Clean the spring pad and axle seat before fitting the new spring so the pack sits flat.
- Check shackle bolts and pins for wear
- Inspect the axle U-bolts for stretch
- Support the axle securely before removing the old spring
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18202.02 |
| UPC | 804314015787 |
| Position | Rear |
| Leaves | 9 |
| Spring quantity | Single spring |
| Bushings | Not included |
| Lift height range | Stock height, direct replacement |
Vehicle fitment
Omix-ADA’s manufacturer list covers the 1959–1960 and 1966–1975 Jeep CJ5 (Base, Renegade) and CJ6 (Base), plus the 1955–1958 Willys CJ-5 and 1956–1958 Willys CJ-6.
Years between the listed ranges, and the CJ7 and Wrangler models, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear 9 leaf spring.
Not included: bushings.








