Overview
The Bilstein 5100 Series front shock absorber, part number 24-274951, is a direct-fit shock for lifted 4WD Ford F-250 and F-350 Super Duty trucks. It is for 2017–2018 models in the King Ranch, Lariat, Limited, Platinum, XL and XLT trims, and is intended for a 2 to 2.5 inch lifted application.
The 5100 Series is a monotube design for consistent, fade-free performance. Its velocity-sensitive, digressive piston responds to changing road conditions, and each shock is tuned for a specific application. The body is smooth and non-coilover with no reservoir, finished in zinc plating.
Key features
- Monotube body for consistent, fade free performance
- Velocity sensitive, digressive piston that reacts to changing road conditions
- Tuned for each specific application
- Direct fit for a 2 to 2.5 inch lifted application
- Smooth body, non-coilover design with no reservoir
- Zinc plated finish
Measuring before you install
Lifted 4WD trucks put extra travel demands on a front shock, so the collapsed and extended lengths matter as much as the part number. With the truck at ride height, measure the space between the mounts and check that the shock can extend fully without bottoming out. Clearance should also be checked at the steering knuckle and brake lines through full steering lock.
Front shocks on Super Duty trucks work alongside heavy springs and the steering system, so worn parts such as ball joints, tie rod ends and control arm bushings should be inspected during replacement. A zinc plated finish helps resist corrosion, but road salt and grit still wear the shaft seal over time. Wipe the shaft clean after off-road trips to keep the seal working.
- Measure mount-to-mount distance at ride height
- Check clearance through full steering lock
- Inspect ball joints and tie rod ends
Specifications
| Brand | Bilstein |
|---|---|
| Part number | 24-274951 |
| UPC | 651860806730 |
| Shock series | 5100 Series |
| Position | Front |
| Drivetrain | 4WD models only |
| Lift range | 2 to 2.5 in. |
| Collapsed length | 13.46 in. |
| Extended length | 21.22 in. |
| Finish | Zinc plated |
| Reservoir | No |
| Body design | Smooth body (non-coilover) |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2017–2018 Ford F-250 Super Duty and 2017–2018 Ford F-350 Super Duty in the King Ranch, Lariat, Limited, Platinum, XL and XLT trims, in 4WD models.
Ford F-250 and F-350 model years outside 2017–2018 are not covered, and Super Duty trucks that are not 4WD fall outside the 4WD-only application. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This shock is intended for a 2 to 2.5 inch lifted application, so confirm your truck’s lift height falls in that range before installing it. Match the part number to your truck, since each unit is tuned for a specific application.
What’s included
One Bilstein 5100 Series front shock absorber. Check the package contents against your installation before starting.









