Overview
The Pro Comp U-Bolt Kit, part number 58201, is a set of U-bolts with hi-nuts and extra thick washers for securing an axle to leaf springs. It is a direct fit kit, so check fit against your vehicle’s year, model and trim first.
The U-bolts are made from low-alloy high strength steel. Round styles are zinc plated, and square styles are left unplated to keep the steel at its bent points intact. They are equivalent in strength to a Grade 5 bolt.
Key features
- Hi-nuts and extra thick washers in the kit
- Low-alloy high strength steel
- Round U-bolts zinc plated; square U-bolts unplated
- Rated equivalent in strength to a Grade 5 bolt.
- Direct fit.
Measuring before you install
U-bolt length decides whether the axle sits correctly on the springs, so measure before the old parts come off. Note the spring pack thickness, the axle tube diameter and the position of the spring seat, then compare them with the new U-bolts. A U-bolt that is too short will not clamp the pack, and one that is too long can bottom on the axle or interfere with brake lines. Keep the old U-bolts for reference until the new set is confirmed.
Work on the axle under support, and tighten nuts in a crisscross pattern so the clamp seats evenly. After the first few drives, check the nuts again, since new spring seats settle and bolts can relax. Inspect the threads on any reused hardware, and replace it if the threads are damaged or the nuts no longer run smoothly. Good preparation makes the install quicker and reduces the chance of rework.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 58201 |
| UPC | 614901111262 |
| Material | Low-alloy high strength steel |
| Finish | Round zinc plated; square unplated |
| Strength | Equivalent to a Grade 5 bolt |
| Included | Hi-nuts and extra thick washers |
| Fitment type | Direct fit (per Pro Comp) |
Vehicle fitment
Pro Comp labels this kit direct fit, but no vehicles, axle sizes or spring packs are named. Measure the spring pack and axle before ordering to confirm that the U-bolt length suits.
Installation notes
Pro Comp says U-bolt lengths are usually adequate for stock and aftermarket leaf spring packs, so check the length against your pack before installing. The included hi-nuts and extra thick washers finish the assembly at the U-bolt ends.
Keep the axle supported until every nut is fully tightened.
What’s included
Hi-nuts and extra thick washers, packaged with the U-bolts.











