Overview
The Pro Comp 13-90321A is a U-bolt made from low-alloy, high-strength steel with strength equivalent to a grade 5 bolt.
A U-bolt holds the axle to the leaf springs or to a lift block, so its length and bend must match the axle diameter and the stack of parts it clamps. Thread size, bend dimensions and the axle size it suits should be checked against the parts you are replacing.
Match the U-bolt to your axle diameter and spring pack, and confirm your year, model and trim before buying.
Key features
- Low-alloy high-strength steel construction
- Strength equivalent to a grade 5 bolt
Measuring before you buy
A U-bolt is a clamp, so the parts it grips matter as much as the bolt itself. Measure the axle tube diameter, count the spring leaves and note any lift block or spacer in the stack. Compare those measurements with the new U-bolt before buying, because a mismatch can pinch the spring, crack the clamp or let the axle shift under load. Keep the axle centered under the spring when you tighten.
Thread length is the other common problem. Lift blocks and thicker spring packs take up thread, so a bolt that worked before may need to be longer. Fresh nuts and washers are a good idea, and any hardware that shows rust or stretched threads should be replaced rather than reused.
- Look for cracks or bends at the U-bolt bend
- Check thread length against the full stack
- Replace worn nuts with new hardware
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 13-90321A |
| Type | U-bolt |
| Material | Low-alloy high-strength steel, grade 5 equivalent |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before buying, and match the U-bolt to the axle diameter and spring or block stack.
U-bolts must match the axle diameter and the spring or block stack, so do not assume fit from the part name. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Tighten the U-bolt nuts to the correct torque once the truck sits at its normal height, then recheck them after the first drive. Confirm the threads have enough length for the nuts and any lift blocks in the stack.
What’s included
One U-bolt.
Not included: nuts and washers.







