Overview
The Pro Comp EXP222530B is a single PRO-X twin tube steering stabilizer for the 1984–1985 Toyota 4Runner and the 1984–1985 Toyota Pickup. It has a 22.37-inch extended length and a 9.24-inch travel length, with stem mounts at both ends.
The stabilizer is designed to improve handling and reduce wheel vibration, which helps limit wear on suspension components. It also helps reduce bump steer when oversized tires or rough roads are involved.
The twin tube design is offered in extended lengths for a range of road conditions. The rebound stop is Teflon, which helps the ride stay comfortable on the highway.
Key features
- PRO-X twin tube design
- Extended length 22.37 inches, travel length 9.24 inches
- 1-3/8 inch nylon banded piston
- 5/8 inch chrome hardened shaft
- Black powder coat finish with stem mounts at both ends
Stem mounts and sizing
A twin tube stabilizer controls steering movement through a damping circuit in the cylinder, so its effect depends on how the piston moves through the tube. Stem mounts take up motion in two directions, which helps the stabilizer work when the axle moves up and down. Stem-mount hardware wears over time, so the rubber and bushings should be checked during routine service.
Check the steering linkage and tie rod ends before fitting a new stabilizer, since loose parts can make the steering feel vague and reduce the benefit. When the truck is raised or fitted with larger tires, look at the travel range again, because the stabilizer may reach the end of its stroke sooner. Keep the stabilizer clear of the exhaust and brake lines.
- Replace worn stem bushings promptly
- Look for oil seepage around the cylinder seals
- Confirm the steering is centered after installation
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXP222530B |
| Series | PRO-X hydraulic steering stabilizer |
| Type | Stabilizer only, single |
| Extended length | 22.37 inches |
| Collapsed length | 13.13 inches |
| Travel length | 9.24 inches |
| Body diameter | 2.0 inches |
| Upper mount | Stem |
| Lower mount | Stem |
| Piston | 1-3/8 inch nylon banded |
| Shaft | 5/8 inch chrome hardened |
| Finish | Black powder coat |
| Brackets included | No |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1984–1985 Toyota 4Runner in the DLX and SR5 trims, and the 1984–1985 Toyota Pickup in the Base, DLX, DLX Turbo, SR5 and SR5 Turbo trims.
Toyota models from other years and the later 4Runner and Tacoma generations are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Stem mounts at both ends need matching hardware on the axle and the steering linkage. Measure the stabilizer against the dimensions above when it arrives, and confirm the mounting points match the axle and steering linkage before installing.
What’s included
The stabilizer is sold individually. Brackets are not included, and the optional shock boot is sold separately.
Not included: brackets and the shock boot.









