Overview
The Pro Comp EXP224000B is a single PRO-X twin tube steering stabilizer with a 23.9-inch extended length, a 14.35-inch collapsed length and a 9.55-inch travel length. It has loop mounts at both ends and a 2.36-inch body diameter.
The stabilizer is designed for a large group of 1973–1991 trucks and utility vehicles, including Chevrolet K10, K1500, K20, K2500 and V-series trucks and Suburbans, GMC K15, K25, C2500 and V-series models, the Ford Bronco and Bronco II, and the Toyota Land Cruiser.
The stabilizer is built to reduce wheel vibration and bump steer, which helps limit wear on suspension components. It suits rough roads and oversized tires.
Key features
- PRO-X twin tube design, offered in extended lengths
- Extended length 23.9 inches and travel length 9.55 inches
- Loop upper and lower mounts
- 1-3/8 inch nylon banded piston on a 5/8 inch chrome hardened shaft
- Teflon rebound stop
Choosing a stabilizer for older trucks
Older trucks often carry bigger tires and heavier bumpers than they left the factory with, which puts more load on the steering. A stabilizer helps control the side-to-side movement of the axle and reduces bump steer on rough ground. Because these trucks are now quite old, the steering linkage, bushings and stem mounts may already be worn.
When choosing a stabilizer for an older truck, the mounting points matter more than the name on the box. Measure the axle and steering linkage, and make sure the collapsed and extended lengths allow full steering travel. Replacement parts for these vehicles are often sourced used, so inspect the cylinder for leaks and bent parts before fitting.
- Replace worn tie rod ends before fitting
- Check the rebound stop for damage
- Look for seepage at the cylinder ends
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXP224000B |
| Series | PRO-X hydraulic steering stabilizer |
| Type | Stabilizer only, single |
| Extended length | 23.9 inches |
| Collapsed length | 14.35 inches |
| Travel length | 9.55 inches |
| Body diameter | 2.36 inches |
| Upper mount | Loop |
| Lower mount | Loop |
| Piston | 1-3/8 inch nylon banded |
| Shaft | 5/8 inch chrome hardened |
| Finish | Black powder coat |
| Brackets included | No |
| Fitment type | Direct fit |
Vehicle fitment
It fits 1973–1991 Chevrolet K10, K1500, K20, K2500 and Suburban models; 1987–1991 V1500, V2500, V10 and V20 models; 1973–1991 GMC Jimmy, K15, K25, K1500 and K2500 models and their Suburban versions; the 1973–1991 Ford Bronco and 1984–1990 Ford Bronco II; the 1975–1977 Ford Bronco Sport; and the 1973–1991 Toyota Land Cruiser. Each model is covered for its own set of trims.
Vehicles outside 1973–1991 are not on this list, so the 1992 and later GM and Ford trucks are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Loop mounts at both ends need brackets that match the axle and the steering linkage, and those brackets are not included. Check the collapsed and extended lengths against the install points.
What’s included
The stabilizer is sold individually, without brackets.
Not included: brackets and the optional shock boot, which is sold separately.









