Overview
The Pro Comp PRO-X twin tube steering stabilizer, part number 220230B, is a single hydraulic steering stabilizer with an extended length of 17.5 inches and 8.16 inches of travel. It is sold individually, and the list covers trucks and SUVs from 1979 to 1991 across several makes.
The stabilizer damps wheel vibration, which can fatigue suspension parts over time. It also helps reduce bump steer caused by oversized tires or rough roads.
The piston is a 1-3/8 inch nylon banded design on a 5/8 inch chrome hardened shaft. Brackets are not included, and the shock boot is optional and sold separately.
Key features
- Twin tube design with a 1-3/8 inch nylon banded piston
- 5/8 inch chrome hardened shaft with a Teflon rebound stop
- Stem mounts at both the upper and lower ends
- Extended length 17.5 inches, collapsed length 10.73 inches, travel 8.16 inches
- Body diameter 2.36 inches with a black powder coat finish
Older trucks and steering upkeep
Stabilizers on older trucks work against steering linkage that has usually been in service for decades. Worn ball joints, tie rod ends and a loose steering box let the wheel move more than the stabilizer can control, so inspect those parts before fitting a new unit. A stabilizer added to a loose front end will wear quickly and may not stop the wander.
Older trucks also tend to have rust on the mounting points. Clean the stem mounts and check for cracks or bent brackets before installing, and use hardware sized to the mounts. Bolts on steering components should be checked for tightness after the first few drives.
- Inspect ball joints and tie rod ends
- Clean and check stem mounts for rust
- Torque fasteners after the first few drives
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 220230B |
| Series | PRO-X hydraulic steering stabilizer |
| Type | Stabilizer only, single |
| Extended length | 17.5 inches |
| Collapsed length | 10.73 inches |
| Travel length | 8.16 inches |
| Body diameter | 2.36 inches |
| Upper and lower mounts | Stem |
| Piston | 1-3/8 inch nylon banded |
| Shaft | 5/8 inch chrome hardened |
| Finish | Black powder coat |
| Brackets | Not included |
| Shock boot | Not included, optional and sold separately |
Vehicle fitment
It fits 1979–1991 trucks and SUVs across several makes. Examples include the 1980–1986 Chevrolet K10 and K20, the 1979–1991 Ford F-150, F-250 and F-350, the 1979–1991 Ford Bronco and the 1984–1991 Toyota 4Runner.
Most models on the list end in 1991, so later Chevrolet, Ford and GMC trucks are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Brackets are not included, so the stabilizer needs brackets obtained separately to attach at its stem mounts.
What’s included
Not included: brackets and the optional shock boot, which is sold separately.









