Overview
The Pro Comp ZX5024 is a rear Pro Runner monotube shock with a long travel bypass design, made for a 4-inch lift. It is a Pro Comp 2.0 Black Series shock, and Pro Comp built it to pair with its Pro Runner control arms.
The monotube body is nitrogen pressurized to reduce cavitation during compression and rebound, which Pro Comp says helps the shock move heat away more efficiently than a twin tube. Pro Comp says its tuning was developed through dyno and real-world testing.
Key features
- Gas charged monotube design
- Nitrogen pressurized body to limit cavitation
- Brushed and zinc plated body with a clear coat
- Multi-stage valving
- Long travel bypass design
Rear shock and axle geometry
A rear shock works with the leaf springs or coil springs, the axle location and the bump stops, so a change in height affects all of them. Lifting the rear changes the shock’s extended and collapsed lengths, which can run a shock out of travel or leave it bottoming out. Measure the mounts and the extended length before the old shock is removed.
Rear shocks also interact with brake lines, sway bars and any track bar in the rear. Check that the brake line has enough slack at full droop, and confirm that the axle does not rotate into the frame at full extension. Heat builds up on long descents, so watch the shock body after a hard trail run.
- Measure extended and collapsed shock lengths
- Check brake line slack at full droop
- Inspect rear bump stops for wear
- Watch shock body temperature on long descents
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | ZX5024 |
| UPC | 614901216608 |
| Position | Rear |
| Lift | 4 inches |
| Series | 2.0 Black Series |
| Type | Long travel bypass shock |
| Charge | Gas charged |
A long travel bypass shock is built to keep a rear suspension working through a large amount of wheel movement, which matters on washboard, whoops and rough trail. The 2.0 Black Series label places this shock in the 2.0 line. Its body is nitrogen pressurized, so the oil stays under pressure during compression and rebound, which reduces cavitation and helps the shock shed heat. The multi-stage valving is tuned so that the shock responds differently at low and high shaft speeds.
Installing a rear shock on a lifted truck changes the shock’s extended and collapsed lengths, so the mounts should be checked before the old shock is removed.
Vehicle fitment
It is part of the Pro Runner series. Check the mounts and shock length against your truck before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear monotube shock.

























