Overview
The Pro Comp ZX2089 is a rear Pro Runner monotube shock absorber for the 2004–2006 Jeep Wrangler (LJ) and the 1997–2006 Jeep Wrangler (TJ). It is designed for a 3 inch lift and is the rear partner to the front ZX2088 for the same two Wrangler generations.
The gas charged monotube body is pressurized with nitrogen, which Pro Comp says prevents cavitation during compression and rebound. The shock is built to shed heat more efficiently than a conventional twin tube. Multi-stage valving is tuned for the application, and the body has a zinc plated, clear coated finish.
The gas charge keeps the oil under pressure, and the multi-stage valving is set for this vehicle, so the shock holds up over repeated compression and rebound. It fits the same LJ and TJ Wrangler years as the front ZX2088 at a 3 inch lift.
Key features
- Rear position, direct fit
- Designed for a 3 inch lift
- Gas charged, nitrogen pressurized monotube
- Multi-stage valving
- Loop upper and lower mounts
Rear shock upkeep on a Wrangler
A rear shock does most of its work when the Jeep is loaded, driven over washboard or run on uneven trail. Over time the seals, eye bushings and valving wear, and the ride starts to feel floaty or bouncy after a bump. Catching this early is simple. Look for oil residue along the body, a dented tube, and play at the loop eyes where the shock bolts to the axle and frame.
Rear shocks are often replaced alongside rear springs, bump stops and brake lines when a Wrangler is lifted, since axle position and suspension travel change. Inspect those parts while the shock is off. Replacing the eye bushings at the same time keeps the mounts tight and cuts down on clunks over rough ground.
- Check the body for oil seepage
- Feel for play at both loop eyes
- Inspect bump stops for cracking
- Recheck mounting bolts after the first trail runs
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | ZX2089 |
| UPC | 614901095005 |
| Shock series | Pro Runner |
| Position | Rear |
| Lift height | 3 in. |
| Body | Monotube, gas charged |
| Finish | Zinc plated, clear coated |
Vehicle fitment
It is a direct fit for the 2004–2006 Jeep Wrangler LJ and the 1997–2006 Jeep Wrangler TJ, at a 3 inch lift.
Wrangler JK and JL models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Both ends are loop mounts, so the rear brackets on the Wrangler must accept a loop eye. Confirm that before installation.
What’s included
One rear Pro Runner monotube shock, sold as each.




























