Overview
The Pro Comp ES3000 Series shock absorber, part number 336009, is a factory-mount twin-tube shock with vehicle-specific lengths. Measure the shock it replaces and check the length and mounting point before ordering.
The gas-charged design uses 10-stage velocity-sensitive valving, a 5/8 inch chrome-hardened piston rod and a Teflon rebound stop. Those specifications give the shock the same basic behavior as the rest of the ES3000 range.
The shock is a gas-charged, twin-tube design, non-adjustable and finished in white. It is sold as a single unit with no boot included, so the main fit check is the length and mounting point of the shock you are replacing.
Key features
- 10-stage velocity-sensitive valving.
- A 5/8 inch chrome-hardened piston rod.
- A Teflon rebound stop.
- Double-welded mounts.
- Limited lifetime warranty from Pro Comp.
Before you buy
Factory-mount shocks reuse the original mounting points, so the fit question is mostly about length and stroke. Measure the shock you are removing at both ends with the vehicle at its normal ride height. Note whether the eye or stud sits at the same spacing as the replacement before buying, since small differences can change how far the shock travels.
Gas-charged twin-tube shocks handle heat more consistently than basic single-tube units, which matters on long descents. Check the piston rod and seals for scoring or fluid seepage at each service, and look at the bushings for cracking. If the truck tows, consider whether the damping level still suits the load.
- Compare extended and collapsed lengths with the old shock
- Check mounts for wear before installing
- Replace in pairs for even damping
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 336009 |
| UPC | 614901336009 |
| Shock series | ES3000 |
| Extended length | Vehicle specific |
| Collapsed length | Vehicle specific |
| Travel length | Vehicle specific |
| Upper mount | Factory |
| Lower mount | Factory |
| Adjustable | No |
| Body type | Gas charged, twin-tube design |
| Finish | White |
| Dust boot included | No |
| Sold as | Each |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before ordering, and measure the original shock before buying.
Lengths are vehicle specific, so a visually similar shock may not match. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Factory mounts should line up with the new shock, but check the full range of movement for clearance with the frame or axle once installed.
What’s included
One ES3000 shock absorber.
Not included: the dust boot. The shock is sold without one.








