Overview
The Pro Comp 41 Series Phaser 17×9 wheel, part number PXA5041-7973, is a 17-inch aluminum split spoke wheel that is 9 inches wide. It uses a 5 on 5 bolt pattern and a satin black finish, part of the 41 Series Phaser satin black range.
The 131 center bore has to match the hub closely. The offset is -6 and the backspacing is 4.75. The wheel is low-pressure cast and universal fit, with no vehicle tied to it.
Key features
- Low-pressure cast aluminum
- 17-inch diameter and 9-inch width
- 5 on 5 bolt pattern
- Center bore 131
- Offset -6 with backspacing 4.75
- Satin black split spoke finish
Choosing the right hub fit
A center bore that is too small for the hub will not slide on, and one that is too large leaves the wheel off center. Measure the hub carefully before buying, and confirm the bore fits without force. Hub-centric rings are used only to close the gap when the bore is larger than the hub.
Satin black finishes benefit from careful mounting. Clean the hub face and the back of the wheel before installation, since rust or grit can cause a wheel to sit slightly out of true. Tighten the lug nuts in a star pattern, and re-check them after the first drives. The -6 offset makes fender clearance a useful second check.
- Clean the hub face before mounting
- Tighten lug nuts in a star pattern
- Check the fender and caliper after the first drive
Specifications
| Brand | Pro Comp Alloy Wheels |
|---|---|
| Part number | PXA5041-7973 |
| Wheel diameter | 17 inches |
| Wheel width | 9 inches |
| Bolt pattern | 5 on 5 |
| Center bore | 131 |
| Offset | -6 |
| Backspacing | 4.75 |
| Style | Split spoke |
| Finish | Satin black |
| Construction | Aluminum |
| Series | 41 Series Phaser |
Vehicle fitment
This wheel is universal fit and is tied to no particular make, model or year. Check the 131 center bore against your hub first, then the -6 offset against the brake caliper and fender.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A center bore that does not match the hub diameter will not seat the wheel, so confirm the hub size before ordering. The negative offset also needs fender clearance checked.
The satin black finish is the 41 Series Phaser look, and the split spoke face is cast from aluminum. The 5 on 5 pattern and 131 center bore should be matched to the hub before the -6 offset is checked against clearance.
What’s included
The product is one 17×9 wheel in satin black. Before starting, confirm you have the center caps and lug nuts your installation calls for.











