Overview
The Power Stop AR8584XPR is a front slotted and cross-drilled brake rotor for the 1999–2002 Ford Expedition, the 2000–2003 Ford F-150 Lightning and the 2000–2002 Lincoln Navigator. The AR8584XPR is made for the front axle, uses cross-drilled holes together with slots, and arrives coated.
Power Stop machines each rotor using Tru-Cast technology and mill balances it, holding run out within 0.0015 and a DTV tolerance specification within 0.005.
The AR8584XPR is a coated, direct-fit rotor, and Power Stop highlights its mill balancing, the zinc plated finish and the slots that keep the pad contact patch clean.
Key features
- Rounded slots clear water, gas and dust
- Cross-drilled holes for cooling
- Silver zinc plating resists rust
- G3000 grade casting
- Tru-Cast precision machining
- Beveled, precision-drilled holes
- Reduces brake fade
- Evolution rotor, mill balanced
- Run out within 0.0015, DTV tolerance within 0.005
- Direct-fit design
Replacing front rotors correctly
Front rotors are usually replaced in left and right pairs, since matched rotors wear evenly and keep steering and braking balanced. Before removing the old rotor, check the hub face for rust, the wheel studs for damage and the caliper bracket for looseness. A clean, flat hub surface matters, because even a small amount of rust can cause runout and pedal pulsation after the new rotor goes on.
Slotted and cross-drilled rotors help clear water, gas and dust from the pad face, yet the holes and slots also wear the pad and collect debris. Pads should be matched to the rotor type and bedded in gradually. Keep brake lines and calipers in good condition during the job, since a leaking line will reduce braking more than any rotor design.
- Clean the hub face and remove all rust before mounting
- Use new hardware where the old parts are worn
- Torque wheel fasteners in a star pattern
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR8584XPR |
| UPC | 792088553157 |
| Type | Slotted and cross drilled |
| Position | Front |
| Coating | Coated |
| Finish | Silver zinc plated |
| Material | G3000 grade casting |
| Machining | Tru-Cast precision machined, mill balanced |
| Tolerances | Run out within 0.0015; DTV within 0.005 |
| Drill holes | Beveled and precision drilled |
| Slots | Rounded slots sweep water, gas and dust |
| Cooling | Drilled holes help keep the rotor up to 180°F cooler. |
| Line | Evolution |
| Fit | Direct fit |
Vehicle fitment
The AR8584XPR fits 1999–2002 Ford Expedition (Eddie Bauer, XLT), 2000–2003 Ford F-150 Lightning and 2000–2002 Lincoln Navigator (Base). The model years run from 1999 to 2003.
It fits 1999–2002 Expedition and 2000–2003 F-150 Lightning models only, not 2003 and newer Expeditions or the regular F-150. Check the year, model and trim against your vehicle before ordering.
Installation notes
Replace front rotors in left and right pairs, and bed in the matching pads with a gradual break-in.









