Overview
The Power Stop JBR917XPR is a front cross-drilled and slotted brake rotor for the 1998–2003 INFINITI QX4 and the 1999–2004 Nissan Pathfinder. It comes from the Evolution series and is a direct-fit performance rotor.
Power Stop describes its drilled and slotted rotors as a blend of cooling holes and pad-cleaning slots, cast in G3000 grade iron. The rotor is machined using Tru-Cast technology, mill balanced and plated with silver zinc to resist rust under normal operation.
Run out is how much the rotor face wobbles as it turns, and DTV is disc thickness variation. This rotor is held to run out within 0.0015 and DTV tolerance within 0.005. It is a direct fit that needs no modification.
The holes and slots do different jobs on this rotor. The beveled holes help keep temperatures down during extreme braking, and the rounded slots sweep water, gas and dust away so the pad keeps a clear contact patch.
Key features
- Cross-drilled holes that Power Stop says hold the rotor up to 180°F cooler
- Rounded slots that sweep away water, gas and dust
- Beveled and precision-drilled holes for extreme braking temperatures
- Run out within 0.0015 and DTV tolerance within 0.005
- Mill balanced, G3000 grade casting
- Silver zinc plated finish that resists rust in normal operation
- Reduces fade
Care and inspection for front rotors
Front rotors take most of the braking load, so they heat up faster and show wear sooner than rear rotors. Pulsation in the steering wheel or pedal often points to a rotor with uneven thickness or a warped face. Check the friction surface for scoring and measure thickness at several points around the disc.
Front rotors and pads should be serviced as a matched set. Mixing a new rotor with worn pads, or the reverse, can lead to uneven braking. Keep the hub face clean and free of rust before mounting, since debris there can throw the rotor out of true.
- Replace front rotors in pairs
- Clean the hub mating surface before fitting
- Check caliper slide pins during each pad change
Specifications
| Brand | Power Stop |
|---|---|
| Part number | JBR917XPR |
| UPC | 792088560742 |
| Product type | Brake rotor, front |
| Rotor design | Slotted and cross drilled |
| Casting grade | G3000 |
| Coating | Coated (silver zinc plated) |
| Location | Front |
| Fit type | Direct fit |
Vehicle fitment
It fits the front axle of the 1998–2003 INFINITI QX4 and the 1999–2004 Nissan Pathfinder.
Model years outside those ranges, including later Pathfinder generations, are not covered by this part number. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fit this front rotor in a pair with its opposite side, with new pads on the axle. Bed in the new surface using a standard pad break-in routine before hard braking. Confirm the front position matches your axle before removing the old rotor.









