Overview
The Power Stop AR8571XPR is a rear slotted and cross-drilled brake rotor for the 2000–2005 Ford Excursion and the 1999–2004 Ford F-250 Super Duty and F-350 Super Duty. The AR8571XPR is made for the rear axle, uses cross-drilled holes together with slots, and arrives coated.
Holes and slots share the work: the holes help lower rotor temperature in extreme braking, and the slots sweep a clear contact patch between pad and rotor to reduce fade.
The AR8571XPR suits owners of 2000-2005 Ford Excursion, 1999-2004 F-250/F-350 Super Duty who want a drilled and slotted look and the cooling holes Power Stop describes, in a direct-fit rear rotor that arrives coated.
Key features
- Cross-drilled holes for cooling
- Rounded slots clear water, gas and dust
- Silver zinc plating resists rust
- G3000 grade casting
- Tru-Cast precision machining
- Beveled, precision-drilled holes
- Reduces brake fade
- Evolution rotor, mill balanced
- Run out within 0.0015, DTV tolerance within 0.005
- Direct-fit design
Rear axle replacement tips
Rear rotors on pickups and SUVs often wear more slowly than the fronts but can rust in areas that see road salt, especially around the hat and the backing plate. Road salt accelerates corrosion on exposed iron surfaces, so inspect the rotor’s outer edge for pitting. Before fitting a new rotor, check the rear caliper pins so the rotor is not held off-square.
Replace both sides of the axle together so braking stays even from side to side. Bed in new pads with moderate stops, and keep the rotor face free of oil or grease. A rotor that shows pulsing, scoring or heat spots should be measured and replaced before it damages new pads.
- Replace both sides together
- Clean rust from the hub mounting face
- Check rear caliper slide pins for free movement
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR8571XPR |
| UPC | 792088553034 |
| Type | Slotted and cross drilled |
| Position | Rear |
| Coating | Coated |
| Finish | Silver zinc plated |
| Material | G3000 grade casting |
| Machining | Tru-Cast precision machined, mill balanced |
| Tolerances | Run out within 0.0015; DTV within 0.005 |
| Drill holes | Beveled and precision drilled |
| Slots | Rounded slots sweep water, gas and dust |
| Cooling | Cooling holes keep rotors up to 180°F cooler. |
| Line | Evolution |
| Fit | Direct fit |
Vehicle fitment
It fits 2000–2005 Ford Excursion in the Eddie Bauer, Limited, XLS and XLT trims, and 1999–2004 Ford F-250 Super Duty and F-350 Super Duty in the King Ranch, Lariat, XL and XLT trims. It is a rear rotor.
The AR8571XPR is a rear rotor. A 2005 F-250 or F-350 Super Duty is not on its list, and the front axle needs a different rotor. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The AR8571XPR is a direct-fit replacement, so it goes on the rear hubs of the listed vehicles in place of the original rotors; replace both sides of the axle together.









