Overview
The Poison Spyder 13-08-050 is a bare steel rocker knocker with a tubular slider, made for the 1987-1995 Jeep Wrangler YJ when it uses TJ fender flares. It guards the rocker panel with 3/16 in plate steel that is cut and formed to follow the body lines.
Rocker panels take hits from underneath and from the sides on tight obstacles. The tubular slider keeps the body sides away from taller rocks and trees, and it can help pivot the vehicle around obstacles and work as a short entry step.
The guard fits flush to the rocker panel, so ground clearance is affected very little. Countersunk holes keep the hardware flush, so the guard slides over obstacles without catching.
Key features
- 3/16 in high strength plate steel, CNC laser cut and brake formed
- Tubular DOM slider welded to the guard with DOM tube spacers
- Countersunk bolt holes for flat head hardware, for a flat surface to slide over obstacles
- Body mounted, with no gap or misalignment when a body lift is installed
- Bare steel finish
Rocker protection on the trail
Rocker panels sit low and take the brunt of rock strikes, mud and salt, so the area under the doors often rusts first. Clean the inside of the rocker and the mounting surfaces before installing the guard, and treat any bare metal with primer. Keep drain holes clear so water does not sit between the guard and the body.
Sliders wear as they are used, so check the tubular section after trail runs for flat spots, bends or weld cracks. Rubber liners sit between the guard and the paint, so they help protect the finish and reduce vibration. Expect some scraping on the first few outings and touch up paint where needed.
- Clean and prime the rocker before mounting
- Keep drain holes clear
- Inspect slider welds after trail use
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 13-08-050 |
| UPC | 614901724325 |
| Type | Formed plate guard with tubular standoff (slider) |
| Material | 3/16 in high strength plate steel; DOM structural tubing slider |
| Fasteners | Stainless steel flat head, countersunk holes |
| Finish | Bare steel |
| Installation type | Cutting or drilling required |
Vehicle fitment
It is made for the 1987-1995 Jeep Wrangler YJ, specifically models that use TJ fender flares.
It is not made for the TJ or other Jeep generations. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting or drilling. Mounting hardware and detailed installation instructions are included.
The guards bolt to the body in key areas and interface with the strengthened areas of the underside of the tub, such as body mounts and strengthening ribs.
What’s included
Rocker knockers with tubular sliders, stainless steel flat head mounting hardware and detailed installation instructions.
Not included: Rubber rocker liners, which Poison Spyder describes as protecting the paint under the guard and absorbing vibration. They must be obtained separately.














