Overview
The Poison Spyder Rocker Knockers, bare steel, part number 13-08-010, are body-mounted rocker panel guards written for the Jeep YJ, which is the Wrangler (YJ) from 1987 to 1995. They are cut from high strength 3/16 inch plate steel and brake-formed to follow the lines of the rocker panel, so the guard sits close to the body with very little loss of ground clearance.
The rocker panels take hits from below and from the sides when a Jeep works through tight obstacles, and this guard is meant to cover that area. The steel is cladding rather than a slider, so it protects the panel itself while the Jeep moves over and around rocks.
Key features
- High strength 3/16 inch plate steel, CNC laser-cut
- Brake-formed to hug the YJ rocker panel lines
- Countersunk bolt holes for flat, unobstructed surfaces
- Bolts to the body in key areas and to strengthened tub sections such as the body mounts
- No gap or misalignment with a body lift
- Stainless steel flat-head hardware for a flush finish
Rocker guards and body protection
A rocker guard takes contact that would otherwise land on the lower body panel. Rocks, stumps and tree edges can dent or tear a rocker when the Jeep crowds a narrow line, and a formed steel plate spreads that load across a wider area. Guards also keep the rocker panel from being driven into the frame edge during a hard crawl over a ledge.
Rocker guards work best when the body and the rest of the underbody are in good shape. Look for rust at the mounting points, loose body bolts, and cracks around the bolt holes after rough trips. Touch up bare steel with a rust-inhibiting primer to slow corrosion, and keep the area between the guard and the body clean so moisture does not sit against the metal.
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 13-08-010 |
| UPC | 614901724257 |
| Type | Formed plate guard |
| Finish | Bare steel |
| Material | High strength 3/16 inch plate steel |
| Fasteners | Countersunk stainless steel flat-head hardware, included |
| Mounting | Body mounts and strengthening ribs |
| Installation | Cutting or drilling required |
Vehicle fitment
These rocker knockers are written for the Jeep YJ, 1987 to 1995, which is the Wrangler (YJ) in the vehicle range used here. Confirm your Jeep is a YJ and not a TJ or CJ before ordering, since the rocker shape follows the body of each model.
Confirm your vehicle’s year, model and trim before ordering. Rubber rocker liners are sold separately and are not included.
Installation notes
The guard bolts to the body and must be drilled to fit, so plan the mounting points before starting. Because the guard mounts directly to the body, it stays in alignment when a body lift is added. Rubber liners are available separately to protect the paint and reduce vibration between the guard and the body.
What’s included
Bare steel YJ rocker knockers with the countersunk stainless flat-head hardware and mounting instructions.









