Overview
The Poison Spyder DIY Slider Tube Kit, bare steel, part number DIY-08-010, is a do-it-yourself kit that adds a rugged DOM tube slider to Poison Spyder Rocker Knockers or other plate steel rocker armor. The kit is written for the Jeep CJ-5, with 39.5 inch main tubes, and it may fit other vehicles if it is a good match, though that is not confirmed. Welding is required.
The kit includes the slider tubes and the short tube supports that brace the middle of each tube against the rocker, enough to do both sides of the Jeep. The slider tubes are CNC bent and pre-notched so they mount at an angle, like the ready-built Rocker Knockers with Sliders.
Key features
- DOM tube slider pieces, CNC bent and pre-notched
- Short tube supports bracing the center of each slider
- Main tubes measure 39.5 inches long
- Kit covers both sides of the Jeep
- Slider mounts at an angle, as on the ready-built versions
Welding a slider to rocker armor
A DOM tube slider takes the hit that would otherwise fall on the rocker armor and the body behind it. When the tube catches a ledge or rock, the load moves along the tube instead of pushing the armor into the frame. The angle of mounting matters, because a slider set at an angle lifts better and sheds obstacles more cleanly than one that runs flat.
Welding is the part that decides how well the slider holds. Clean the contact areas to bare metal, tack the supports in place and check the alignment before running full welds. Weld in short passes to limit heat distortion, and let the joint cool before loading it. After the first few trail runs, check the welds for cracking near the supports, since those spots flex the most.
- Grind contact areas to bare metal
- Tack both supports before full welds
- Weld in short passes to limit distortion
- Inspect the welds after the first trail runs
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | DIY-08-010 |
| UPC | 614901732399 |
| Type | Tubular guard, DIY kit |
| Finish | Bare steel |
| Main tube length | 39.5 inch |
| Components | Slider tubes and short tube supports |
| Installation | Welding required |
Vehicle fitment
The kit is made for the Jeep CJ-5, and it should be checked against any other vehicle before welding. Confirm your CJ-5 falls in the 1959 to 1983 range before you start.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, so the kit suits someone able to weld the tubes to the rocker. Check the slider angle and the short supports against the guard before welding, because the tubes are pre-notched and set to mount at an angle.
What’s included
Slider tubes for both sides, the short tube supports, and the bare steel tubing ready to weld.









