Overview
The Poison Spyder Ricochet Rockers, bare steel, part number 12-50-010, are formed rocker armor with a 5 inch dimpled step and slider. They fit the 1981 to 1985 Jeep Scrambler. The assembly combines rocker protection with an entry step, so it works as both armor and a foothold. The step, slider and gussets arrive welded as one assembly, so the installer only has to fit and mount it. The assembly is professionally welded, and the step plate is 5 inches wide with dimples placed so the foot grips the metal.
The dimpled step plate is reinforced underneath and gives grip when boots are wet with snow or mud. Used together with Crusher Corners, the Ricochet Rockers and the corners protect the body from the front wheel well to the tailgate, and the two pieces meet at the rear flare area.
Key features
- 5 inch dimpled step plate
- Dual tube support and slider bar of 1.5 inch DOM tubing
- Step and corner gussets of CNC laser-cut 3/16 inch steel
- Brake-formed gussets for strength
- Professionally welded and ready to paint
- Works alone or with Crusher Corners
Choosing a step and armor setup
Rocker armor on a Scrambler takes the first hit from rocks, stumps and ledges as the Jeep climbs or slides along a trail. A boxed rocker with a step adds a second job: it gives a boot somewhere solid to land when getting in and out, which matters on mud or snow. Before buying, think about how you enter the vehicle most often. A wide, grippy step suits frequent off-road use, while plain armor may be enough for a Jeep used mostly on dirt roads.
Because the step and slider are welded into one assembly, the fit around the cab and rear flare matters more than it would with bolt-on accessories. Measure the clearance between the rocker and the tire at full steering lock, and check that the step will not rub the sidewall. Pairing rockers with corner guards is common on this kind of build, since the two pieces cover the body together.
- Check tire clearance at full steering lock
- Plan paint work before drilling
- Inspect welds after rough trail use
- Recheck fasteners after the first few trail runs
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 12-50-010 |
| UPC | 614901723878 |
| Type | Formed plate guard with tubular standoff |
| Finish | Bare steel, ready to paint |
| Step | 5 inch dimpled plate |
| Slider tube | 1.5 inch DOM, dual tube support |
| Gussets | 3/16 inch steel, CNC laser-cut |
| Fasteners | Countersunk 3/8 inch stainless |
| Installation | Cutting or drilling required |
Vehicle fitment
These rockers fit the 1981 to 1985 Jeep Scrambler. Confirm your Jeep is a Scrambler and that its year falls in that range before ordering, because the step and slider are shaped to that body.
Confirm your vehicle’s year, model and trim before ordering. Rubber liners are sold separately.
Installation notes
Check the step height against your Jeep before drilling. Plan on cutting or drilling, then fasten the rockers with the countersunk 3/8 inch stainless hardware. Detailed installation instructions come with the kit. Rubber liners are available separately to protect the paint and reduce vibration.
What’s included
Scrambler Ricochet Rocker, with its dimpled step, slider and countersunk hardware.
















