Overview
It is a bare steel front bumper for the Jeep Wrangler JK. It is a grille-width, high clearance design that pairs hard core off-road performance with full features.
It is CNC laser-cut and brake-formed from 3/16″ plate steel, and the ends extend far enough to protect the lower corner of the JK grille without hindering tire clearance or tire access. Unlike the Poison Spyder BFH series bumpers for JK, the Brawler Lite can be mounted without cutting or altering the frame rails.
The faceted shape gives the Brawler Lite high ground clearance and approach angle in a bumper that mounts without frame modifications. The plate steel is CNC laser-cut and precision brake-formed into a low profile shape.
The part is supplied as bare steel.
Poison Spyder gives the ends of the bumper a specific job: they extend far enough to protect the lower corner of the JK grille, but not far enough to hinder tire clearance or tire access to vertical obstacles.
Key features
- Low profile, high clearance design in 3/16″ plate steel
- Mounts without cutting or altering the frame rails
- Recessed buckets for the factory fog lamps
- Factory crash bar can stay or be removed
- Faceted design for ground clearance and approach angle
- 2-door and 4-door models
Finishing bare steel
Bare steel bumpers rust quickly once the mill scale and shop film are gone, so plan the finish before the bumper goes on the Jeep. Clean the steel with a degreaser, scuff it, and apply a primer before paint or powder coat. Mask the mounting holes and threads so the coating does not fill them and make the bolts hard to start.
Choosing between paint and powder coat comes down to how the bumper will be used. Powder coat is tough against rock chips, while paint is easier to touch up on the trail. Either way, bare steel edges and welds are where rust starts first, so check them each season and recoat any chips.
Fog lamp buckets and the winch area take the most abuse. After installation, inspect the bolts and bracket mounts after the first few trail runs, and tighten anything that has worked loose.
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 17-59-010 |
| UPC | 614901727159 |
| Product type | Front bumper |
| Position | Front |
| Material | Steel, 3/16 inch plate |
| Finish | Bare |
| Width | Mid |
| Fog lamp mounting | Recessed buckets for factory fog lamps |
| Body styles | 2-door and 4-door |
| Fit type | Direct fit |
Vehicle fitment
It is the Brawler Lite front bumper for the Jeep Wrangler JK, covering the 2007–2018 Wrangler (JK) generation.
Confirm fit for your vehicle’s year, model and trim before ordering, especially for the YJ, TJ, LJ and JL Wranglers.
Installation notes
No cutting or alteration of the frame rails is needed. The factory crash bar can stay or be removed, and the optional Brawler Lite Skid Plate, a separate item, covers the crash bar and the electronic sway bar disconnect.
















