Overview
The Poison Spyder JK Body Armor, bare steel, part number 18-08-410, is a 3/16 inch steel armor panel written for the 4-door Jeep JK. It protects the thin factory sheet metal of the body, and it hugs the Jeep’s body contours so the armor adds no loss of ground clearance. The armor can be used by itself or alongside the factory Rubicon rocker rails and Poison Spyder JK Rocker Knockers.
JK Body Armor is recommended for any JK that will be used off road where body damage is likely. When used with the factory Rubicon rocker rails, it helps stop rocks from pushing the rails up into the body. When used with Rocker Knockers, it gives one more line of defense for the rocker area.
Key features
- 3/16 inch steel plate, CNC laser-cut and precision brake-formed
- Hugs the Jeep’s body contours
- No loss of ground clearance when used alone
- Spyder logo CNC cut into the armor
- Countersunk bolt holes and stainless flat-head cap screws
- Can be painted, powder coated, polished or clear-coated before installation
Protecting the body and rockers
Factory body panels on a JK are thin, and rocks or brush can dent or crack them during off road use. Armor that follows the body lines spreads impacts across a wider area, so a single strike is less likely to reach the sheet metal behind it. Careful fitting keeps the panel close to the body without gaps where debris can collect.
Bare steel needs attention before and after installation. Coating it protects against rust, especially at drilled holes and edges. Once mounted, watch for paint chips and scrapes, which are the first places moisture can start corrosion, and touch them up promptly.
- Coat all drilled edges before installation
- Check bolts after the first few off road trips
- Clean mud from the gap between armor and body
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 18-08-410 |
| UPC | 614901727616 |
| Type | Formed plate guard |
| Finish | Bare steel |
| Material | 3/16 inch steel plate |
| Fasteners | Stainless steel flat-head cap screws |
| Bolt holes | Countersunk |
| Installation | Cutting or drilling required, body drilling |
Vehicle fitment
The JK Body Armor is for the 4-door Jeep JK, which is the Wrangler (JK) from 2007 to 2018. Confirm your Jeep is a 4-door JK and that its body contours match the armor before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Drilling of the body is required for installation. The armor can be painted or powder coated before it goes on, and the stainless flat-head cap screws give a clean, flush surface once it is bolted in.
Because the armor is bare steel, paint or powder coat it before installation to protect it from rust. Used with the factory Rubicon rocker rails, it helps prevent rocks from pushing the rails up into the body.
What’s included
One bare steel JK Body Armor panel with countersunk bolt holes and stainless steel flat-head cap screws.









