Overview
The Poison Spyder 14-16-020-DC is a BFH front bumper with a Comp Stinger and recovery shackle tabs, in bare 3/16-inch plate steel. The BFH name stands for Built For the Hammers, and the design aims for strong ground clearance, tire clearance and approach angle.
The Comp Stinger suits owners moving into harder off-road use. It improves forward-roll prevention and adds protection for the radiator area and engine compartment in a rollover. It extends 17.6 inches forward from the front edge of the bumper and stands 21.9 inches high above the top surface. The bumper is cut from one piece of plate, has an integrated winch mount and is no wider than the frame rails.
Poison Spyder machines the Recovery Shackle Tabs from 1″ thick plate steel as a secure attachment point for 3/4″ recovery shackles. They are engineered to match the angles of the BFH bumper, which results in zero loss in approach angle, and the bumper is cut from high strength plate and brake-formed for an exact fit.
Key features
- Cut from a single piece of high strength 3/16″ plate steel
- Integrated winch mount and one-piece design
- Comp Stinger for forward-roll prevention and radiator protection
- Stinger extends 17.6″ forward and is 21.9″ high
- Angled facets help the bumper slide over rocks
- Recovery shackle tabs machined from 1″ thick plate steel for 3/4″ shackles
Built for trail protection
A front bumper does more than look aggressive. On the trail it takes the first impact from rocks, stumps and ledges, and it protects the grille, lights and radiator from direct contact. The angle of the bumper face and the height of its lower edge both affect how the vehicle approaches an obstacle, so a bumper that slides over rock is often preferred over one with sharp corners.
Bare steel suits owners who plan to paint or powder coat the bumper to their own spec. Prepare the metal by removing mill scale and oil, then prime it before the topcoat. Mounting a winch and fairlead is a separate job, so plan the wiring and the winch’s weight at the same time as the bumper install.
- Check the winch and fairlead fit before drilling
- Inspect the shackle tabs for cracks after hard recoveries
- Recheck bolts after the first few trail runs
Specifications
| Brand | Poison Spyder |
|---|---|
| Part number | 14-16-020-DC |
| UPC | 614901725797 |
| Type | BFH front bumper with Comp Stinger and shackle tabs |
| Material | 3/16″ plate steel |
| Finish | Bare steel |
| Width | No wider than the frame rails |
| Stinger projection | 17.6″ forward, 21.9″ high |
| Winch mount | Integrated |
| Shackle tab stock | 1″ thick plate steel, for 3/4″ shackles |
Vehicle fitment
Confirm the Jeep model, year and trim this bumper is intended for before you order.
Compare the bumper’s mounting points with your frame before installing.
Installation notes
The tabs are engineered to match the bumper’s angles, which Poison Spyder says results in zero loss in approach angle. The bumper is bare steel and needs paint or powder coat, and a winch fairlead is a separate part.
What’s included
- BFH front bumper with Comp Stinger
- Recovery shackle tabs
Not included: a winch, a fairlead and paint or powder coat.









