Overview
The Poison Spyder Customs 2-1/2 inch LED back-up light, part number 41-04-300, is a clear LED reverse light that mounts flush in a 2-3/4 inch hole. It is not vehicle-specific.
The light is designed for Poison Spyder Customs RockBrawler bumpers, Crusher Corners and Trail Corners, and for other manufacturers’ corner protectors. It can also go anywhere a 2-3/4 inch hole can be cut in a flat sheet metal panel.
Key features
- Clear LED back-up light
- 2-1/2 in flush mount design
- Push-in mounting with a rubber grommet
- Works with Poison Spyder corner protectors and other flat sheet metal panels
Wiring and placement tips
A back-up light only helps if it is wired to switch on when the vehicle is in reverse. Route the power through a fuse close to the battery or fuse block, and use a relay if the light draws enough current to strain the reverse circuit. Keep the leads away from exhaust heat, sharp edges and suspension travel.
Placement matters for visibility and for the lens. Mount the light where the hole is flat and clear of bends in the sheet metal, and leave room behind the panel for the wires and the rubber grommet. Test the light with the engine running before closing up the panel, so any wiring fault is easy to reach.
Light from a flush mount is best when the lens is kept clean. Wash it with mild soap and avoid abrasive cleaners that can cloud clear plastic lenses over time.
- Fuse the circuit close to the power source
- Use a relay if current draw is high
- Test before sealing the panel
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 41-04-300 |
| UPC | 614901728033 |
| Light type | LED |
| Lens color | Clear |
| Light size | 2-1/2 in |
| Mounting hole | 2-3/4 in |
| Mounting | Push-in with rubber grommet |
| Fitment | Universal |
Vehicle fitment
This light is not vehicle-specific, so no year, make or model applies. The sizing constraint is the 2-3/4 inch mounting hole in a flat sheet metal panel.
Installation notes
The light requires wiring, so run it through a fused circuit and check local road-use rules for auxiliary reverse lights before installing. Keep the wiring clear of moving parts.
What’s included
One clear LED back-up light with a rubber grommet for push-in mounting.
Not included: wiring, and the 2-3/4 in mounting hole, which you cut yourself.
















