Overview
Part 15-SK12 from G2 Axle and Gear is a pinion shim for the differential carrier. It positions the pinion gear so the ring gear teeth engage at the correct depth. It carries UPC 682034187942.
Checking pinion depth at install
Pinion depth is the first thing to verify when a new shim goes in, because it decides where the ring gear teeth meet the pinion. A shim that is off by a small amount can change the contact pattern enough to cause noise. Measuring the existing depth before removing the old shim gives a useful baseline.
After the depth is set, confirm the pinion bearing preload and then recheck the gear mesh. Shims are often replaced along with the pinion nut and any crush sleeve, since each affects the final setup. Keep the carrier clean and the mating faces free of burrs so the shim sits flat.
- Measure the existing pinion depth first
- Confirm pinion bearing preload after setting depth
- Replace the crush sleeve with the shim when used
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 15-SK12 |
| UPC | 682034187942 |
Vehicle fitment
Verify the axle and carrier application before fitting it to any differential.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion shims are usually sized by measurement during gear setup, so pinion depth should be checked before any shim is swapped in.
What’s included
Count and thickness should be matched to your gear setup before use.






