Overview
It is a solid pinion spacer kit with shims for Toyota 8 Inch axles, intended for 4cyl vehicles. It replaces the factory pinion crush sleeve and helps keep the pinion setup preload from loosening. Toyota moved away from solid spacers decades ago to speed up production.
Key features
- Solid spacer and shims replace the original pinion crush sleeve
- Helps prevent the pinion gear setup preload from loosening
- Avoids the need to keep retorquing the pinion nut
- Used on front or rear Toyota 8 Inch axles.
- Intended for 4cyl vehicles.
Pinion preload and wear
Pinion preload is the rotating drag set on the pinion bearings. If it drops, the pinion can move under load and wear the ring and pinion teeth, so it is worth checking the setup any time the carrier is opened or the pinion nut is loosened.
Crush sleeves compress as the nut is tightened, which is why they are usually replaced rather than reused. Solid spacers avoid that step, but they need shims chosen carefully during setup. Keep a record of the shim stack and the preload reading so the job can be repeated later. A carrier that runs warm or whines after the change often points back to preload, so recheck the setup before blaming the gears.
- Inspect the ring and pinion teeth for wear
- Replace the pinion seal when the nut is removed
- Check the pinion bearings for roughness
- Keep the original shim stack for reference
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140059-1-KIT |
| UPC | 70000621536 |
| Axle location | Front or rear |
| Axle type | Toyota 8 Inches |
| Application | 4cyl vehicles |
| Contents | Solid spacer and shims |
Vehicle fitment
The kit is sized for Toyota 8 Inch axles on 4cyl vehicles. Match your axle and engine before ordering.
Use it only with Toyota 8 Inch axles. Check your year, model and trim against the axle before ordering.
Installation notes
The solid spacer takes the place of the crush sleeve, so setup takes a little longer. Set the pinion preload with the shims in the kit before the final torque. Pinion preload work is careful work, since incorrect preload shortens bearing life.
What’s included
The solid pinion spacer and shims.
Not included: the pinion gear and carrier.






