Overview
The Trail Gear 140060-1-KIT is a solid pinion spacer kit for Toyota 8 Inch axles, fitting front and rear locations. A solid spacer replaces the factory pinion crush sleeve, and the included shims set the pinion gear preload.
Key features
- Replaces the original pinion crush sleeve with a solid spacer
- Solid spacer and shims included
- Keeps the pinion gear setup preload from loosening
- Fits front and rear Toyota 8 Inch axles
Setting pinion preload
A solid spacer changes how pinion preload is set. Instead of tightening the nut to crush a sleeve, you install shims that control how far the pinion seats. Plan extra time for this step, and keep the carrier clean so the bearings seat evenly as the nut is brought up.
After setup, run the axle through a short test before heavy trail use. Listen for whine or roughness at speed, and check the pinion nut and bearing caps for any movement. Keep a record of the shim stack, since it is needed if the gears are ever replaced.
- Keep the carrier and bearings clean
- Dry-fit the shims before final assembly
- Test the axle at low speed first
- Record the shim stack for future service
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 140060-1-KIT |
| UPC | 70000621538 |
| Axle location | Front or rear |
| Axle type | Toyota 8 Inch |
| Contents | Solid spacer and shims |
Vehicle fitment
Confirm your vehicle’s year, model and trim before ordering. The kit is for Toyota 8 Inch axles at both front and rear locations.
Axles of other sizes and makes are not covered by this kit.
Installation notes
Setup takes longer than a crush sleeve, so allow extra time to dial in pinion preload. Once it is set, the pinion nut should hold without repeated retorquing.
What’s included
The solid spacer and shims.
Not included: the pinion gear and carrier.






