Overview
The Omix-Ada tie rod, part number OAI18058.01, is a front steering tie rod that runs from the pitman arm to the knuckle. It is 23.94 inch long and fits the 1972–1983 Jeep CJ5 and the 1976–1981 Jeep CJ7.
The tie rod is built to original specifications and carries a limited five year warranty from Omix-Ada.
Key features
- Runs from the pitman arm to the knuckle
- 23.94 inch long
- Front position
- Limited five year warranty from Omix-Ada
Front steering linkage basics
The front tie rod sits between the pitman arm and the steering knuckle, moving the front wheels as the steering wheel turns. Its ball joints wear with miles and with dust and road grime entering the boots. Once a joint becomes loose, the steering gets vague and the tires can wear unevenly, so a worn tie rod should be replaced rather than run until it fails.
When fitting a new tie rod, check the threads and taper on both ends and clean the mating surfaces. Keep the length consistent with the original so the wheel alignment stays close to its previous setting. After installation, have toe checked and set to the correct specification.
- Check the boots for cracks or leaks
- Feel for play at each joint
- Watch for uneven front tire wear
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI18058.01 |
| Length | 23.94 inch |
| Connection | Pitman arm to knuckle |
| Position | Front |
| Warranty | Limited five year warranty |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1972–1983 Jeep CJ5 in Base, Golden Eagle, Laredo, Limited and Renegade trims, and the 1976–1981 Jeep CJ7 in Base, Golden Eagle, Golden Hawk, Laredo and Renegade trims.
The CJ6, Cherokee (XJ) and Wrangler (YJ) are not covered here. Confirm fit for your vehicle’s year, model and trim before ordering.
What’s included
One tie rod is included. No other hardware is included, so check the package contents against your installation before starting.










