Overview
The Omix-ADA OAI12027.01 is a rear frame crossmember for early Jeep CJ3, CJ5 and CJ6 models and Willys CJ-3, CJ-5 and CJ-6 models. It is 1/8 inch thick and comes unpainted.
Welding is required for installation. Paint the crossmember after installation to prevent corrosion, since it ships unpainted. The top flange is 53-1/2 inches long.
Key features
- Rear frame crossmember
- 1/8 inch thick steel
- Top flange 53-1/2 inches long
- Unpainted, so it needs paint after installation
- Crossmember included
Welding and rust protection
A rear crossmember ties the frame rails together and carries the rear body mounts, so its welds carry real load on a Jeep CJ. Before welding, grind the joint area to clean metal and check the frame rails for cracks or thin spots. Fit the crossmember square to the frame and tack it in place before the final welds.
Welding a crossmember with heat can change the steel near the joint, so let the work cool and inspect the weld bead afterward. Use a weld pattern that spreads heat evenly, and avoid long single runs in one spot. Test-fit the shock mounts and any other attachments before the final weld, since correcting after welding is harder.
Painting after the job protects both the new crossmember and the welded seams. Use a rust-inhibiting primer on bare metal and a topcoat suited to the vehicle use.
- Grind joints to bright metal
- Tack weld and check alignment before final welds
- Prime and paint all seams after welding
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | OAI12027.01 |
| UPC | 804314044213 |
| Position | Rear |
| Material | Steel, 1/8 inch thick |
| Top flange length | 53-1/2 inches |
| Finish | Unpainted |
| Installation | Welding required |
| Bolt-on shock mounts | Not included |
| Pinion snubber bracket | Not included |
| Fitment type | Direct fit |
Vehicle fitment
The fitment data covers the 1959–1960 and 1966 Jeep CJ3 (Base), the 1959–1960 and 1966–1975 Jeep CJ5 (Base and Renegade), the 1959–1960 and 1966–1975 Jeep CJ6 (Base), and the 1955–1958 Willys CJ-3, CJ-5 and CJ-6.
The fitment data does not include the CJ5 from 1961 to 1965, the CJ7 from 1976 to 1986 or the Scrambler. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Welding is required, so the crossmember should be welded in place by someone able to weld frame sections. Paint it after installation, because it ships unpainted and corrosion is a risk.
What’s included
The crossmember is included.
Not included: bolt-on shock mounts and a pinion snubber bracket.









