Overview
The Kentrol RB4068R is a passenger side torque box repair section that strengthens the frame rails of the 1997 to 2006 Jeep Wrangler TJ.
The section slides onto the frame on an EZ slip design and includes the factory-needed holes and mounting locations. It is made from .125-inch cold rolled steel and ships raw and uncoated.
Key features
- Passenger side torque box for the frame rails
- EZ slip design slides onto the frame
- Includes factory-needed holes and mounting locations
- Made from .125-inch cold rolled steel
- Ships raw and uncoated, welding required to install
Protecting bare steel after install
Bare steel left after welding starts to rust quickly, especially at the weld seams and where the torque box meets the frame rail. Grind and wire brush the weld area, then clean off any oil or mill scale so the coating can bond properly before it is applied. Heat from welding also dries out nearby paint, so expect that area to need extra attention.
Choose a coating that suits the work, such as a rust-inhibiting primer followed by a topcoat, and cover the inside seams where moisture collects. Keep the fuel lines and wiring out of the spatter path, and recheck the coating each season for chips or peeling areas.
- Grind weld areas and remove mill scale
- Apply primer before any topcoat
- Coat inside seams where moisture collects
- Inspect coatings each season for chips
Specifications
| Brand | Kentrol |
|---|---|
| Part number | RB4068R |
| Position | Passenger side |
| Material | .125-inch cold rolled steel |
| Finish | Raw, uncoated |
| Installation | Welding required |
| Fitment | Direct fit |
Vehicle fitment
It is a direct fit for the 1997 to 2006 Jeep Wrangler TJ in 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims.
It is for the TJ generation. Compare your vehicle’s year, model and trim with those trims before ordering.
Installation notes
Welding is required, and the part ships raw and uncoated, so it needs protective coating after installation. Shield nearby wiring and fuel lines while welding.
What’s included
Bolts, brackets and welding materials should be sourced for the installation.
Not included: Welding equipment and protective coating are needed to complete installation.











