Overview
The Omix-ADA 16733.05 is a rubber rear brake line for the 1987–1995 Jeep Wrangler (YJ). Omix-ADA describes its Jeep parts as direct OE replacements built to the original specifications, and this hose comes pre-assembled as a complete rear brake line.
Key features
- Rear position brake line for the Wrangler YJ
- Rubber construction
- Stock length, sized for 0 to 2 inch lift heights
- Direct-fit replacement that comes pre-assembled
- Backed by a limited five year warranty
Bleeding after a line swap
Replacing a brake line opens the hydraulic circuit, so air can enter and the fluid can pick up moisture. Bleeding the affected circuit removes trapped air and restores a firm pedal. Work methodically, starting at the wheel farthest from the master cylinder and moving closer, and keep the fluid reservoir from running dry during the process.
Use fresh brake fluid from a sealed container, since old fluid absorbs moisture and can lower its boiling point. Wipe away dirt around the fittings before loosening them, and check each joint for leaks once the system is pressurized. A pedal that feels soft or spongy after the work usually means air is still in the line.
- Use fresh fluid from a sealed container
- Clean fittings before loosening them
- Keep the reservoir topped up during bleeding
- Check every joint for leaks before driving
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16733.05 |
| UPC | 804314050948 |
| Position | Rear |
| Type | Rubber |
| Length | Stock |
| Size | 0 inches to 2 inches |
| Fit | Direct fit |
| Warranty | Limited five year warranty |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler (YJ).
Confirm fit for your vehicle’s year, model and trim before ordering, particularly for the 1997–2006 Wrangler (TJ) or 2007–2018 Wrangler (JK).
Installation notes
A rubber hose replaced at the rear of the brake system means the circuit has to be bled before the Wrangler is driven.
What’s included
Pre-assembled rear brake line.









