Overview
The Omix-ADA 16732.01 is a rubber front brake line for early Jeep CJ and Willys models, made for vehicles with 9 inch brakes. The hose is 6 inch overall length and sits at the front brakes at stock height.
Key features
- For vehicles with 9 inch brakes
- 6 inch overall length
- Rubber construction, front position
- Stock length for 0 to 2 inch lift heights
- Direct-fit replacement in the original style, with a limited five year warranty.
Matching hose to brake size
A front brake hose carries fluid from the frame-mounted line to the caliper or wheel cylinder, and it flexes with suspension travel and steering movement. Rubber hoses are a common choice for early CJ and Willys restorations because they match the original look and routing, but they age with heat and exposure, so the condition of an old hose matters as much as its size.
Brake size affects which hose will reach the correct fitting without strain. Before buying, confirm the brake size on the axle and the lift height of the vehicle, since a lift can stretch a hose that is already at its limit. A hose that is too short or routed tight against the tire can crack quickly, so check the path through the full range of steering movement.
- Confirm brake size on the axle before ordering
- Check the route through full steering travel
- Inspect the old hose for cracks and soft spots before removing it
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16732.01 |
| UPC | 804314013073 |
| Position | Front |
| Type | Rubber |
| Brake size | 9 inch brakes |
| Overall length | 6 inch |
| Length class | Stock |
| Size | 0 inches to 2 inches |
| Fit | Direct fit |
Vehicle fitment
It fits the 1959–1960 and 1966 Jeep CJ3, CJ5 and CJ6, the 1946–1949 Willys CJ-2, the 1949–1958 Willys CJ-3, the 1955–1958 Willys CJ-5, the 1956–1958 Willys CJ-6 and the 1941–1942 Willys MB.
Later CJ5 and CJ6 years are not covered by this part number, and the hose is for 9 inch brakes only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because this hose is made for 9 inch brakes, check the brake size on your axle before fitting it, then bleed the system after the swap.
















