Overview
The Omix-ADA 16737.51 is a full steel brake line kit for Jeep vehicles, sold as a direct OE-style replacement. The steel brake lines are custom CNC-bent to a blueprint specification and come with OEM-style fittings.
The lines are built to original specifications, which supports a good fit and long service life. The kit is a complete set of steel hard lines only, so rubber lines are not included, and it does not fit vehicles with ABS. A limited five-year warranty applies.
Confirm the year, model and trim against this kit before ordering.
Key features
- Full brake line set in steel
- Custom CNC-bent to blueprint specification
- OEM-style fittings included
- Direct OE replacement built to the original specifications
- Does not fit vehicles with ABS
- Limited five-year warranty
Brake line replacement planning
Brake lines carry fluid under high pressure, so a replacement set is only as good as the work around it. Before starting, identify which lines are being replaced, note the routing and clip positions, and check the master cylinder, proportioning valve and hose ends for wear. Replacing lines alone will not fix a soft pedal caused by air or a worn caliper.
Fluid compatibility matters too. Use fresh brake fluid of the type the vehicle requires, and keep the reservoir topped up while bleeding. Pay attention to flare fittings, which must seat squarely without cross threading. A damaged flare can leak after a few miles, so inspect every connection once the system is pressurized.
- Mark line routing before removal
- Replace clips that are cracked or weak
- Keep brake fluid clean and sealed
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16737.51 |
| UPC | 804314160760 |
| Product type | Steel brake line kit |
| Material | Steel |
| Fittings | OEM style |
| Rubber lines | Not included |
| ABS compatibility | Does not fit with ABS |
| Warranty | Five-year limited coverage |
| Fitment type | Direct fit |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before ordering. This kit does not fit vehicles with ABS, so check whether your vehicle has ABS first.
Because no models or years are stated, do not assume this kit fits any particular Jeep. Vehicles equipped with ABS are not covered by this kit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Brake components are safety-critical, so a professional installer should do the work. Torque every fastener and fitting to the specified values.
- Support the vehicle on rated jack stands on level ground; never work under a vehicle held only by a jack.
- Bleed the brake system as the manufacturer instructs and check for fluid leaks at every fitting.
- Test the brakes at low speed in a safe area before returning to normal driving.
- Re-check fittings and fasteners after the first miles of driving, and inspect them at regular service intervals.
What’s included
A full set of steel brake lines with OEM-style fittings.
Not included: Rubber brake lines are not included.









