Overview
The Omix-Ada 16919.08 is a lower clutch rod for Jeep CJ5, CJ6, CJ7 and Scrambler models from 1972 to 1986. It is a direct replacement built to original specifications.
The lower rod is one link in the mechanical clutch linkage. Measure its length and mounting points against your old rod before installing.
Before you install
A clutch lower rod is one part of the mechanical linkage that carries pedal movement to the clutch release mechanism. Because each link transfers load, a rod that is bent, worn at its ends or loose in its fastenings can cause a clutch that feels vague, engages high in its travel, or fails to release fully. Before replacing one, inspect the connected linkage as a set, since worn pivots, bushings and return springs often wear alongside the rod.
When fitting a new rod, set the linkage free play as the vehicle’s service procedure describes, then road test the clutch at low speed in a safe area. Check that the pedal returns smoothly and that the release point does not change under load. Keep the clevis pins and clips clean and replace any that are deformed.
- Check the rod ends for play
- Inspect the clevis pins and clips
- Confirm the pedal returns fully
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16919.08 |
| UPC | 804314042714 |
| Part type | Lower clutch rod |
| Fit type | Direct fit |
Vehicle fitment
It fits these models:
- 1972-1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1972-1975 Jeep CJ6 (Base)
- 1976-1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade)
- 1981-1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR)
CJ5 models after 1983 and Scrambler models after 1985 are not on this list.
Confirm your vehicle’s year, model and trim before ordering.









