Overview
The Omix-Ada 16918.01 is a clutch fork boot for 1972 to 1975 Jeep CJ5 and CJ6 models. It is made for 6 and 8 cylinder engines and fits as a direct OE replacement.
A clutch fork boot is the rubber cover that sits over the clutch fork pivot area. This boot measures 4 inch x 2.5 inch with a 1 inch center flap.
Key features
- Direct OE replacement built to original specifications
- Made for 6 and 8 cylinder engines
- Measures 4 inch x 2.5 inch with a 1 inch center flap
- Omix-Ada part number 16918.01
Keeping the fork pivot sealed
A boot keeps road grit, water and mud away from the fork pivot and pushrod, areas that wear quickly when left exposed. On a vehicle driven off-road, a cracked boot lets sand work into the pivot and can turn a simple seal replacement into a fork and bearing job. Looking at the boot during routine clutch checks is a quick way to catch that damage early.
Replace the boot if it is split, hardened, or no longer seats around the fork. Clean the pivot area before fitting the new boot so no debris is trapped underneath, and avoid stretching the rubber over sharp edges. Because the boot sits near the bellhousing, check it after any transmission or clutch work.
- Look for splits along the fold lines
- Clean the pivot area before fitting
- Check the seal after any bellhousing work
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16918.01 |
| UPC | 804314023386 |
| Part type | Clutch fork boot |
| Engine | 6 and 8 cylinder engines |
| Size | 4 inch x 2.5 inch |
| Center flap | 1 inch |
| Fit type | Direct fit |
Vehicle fitment
Omix-Ada places this boot on:
- 1972-1975 Jeep CJ5 (Base, Renegade)
- 1972-1975 Jeep CJ6 (Base)
CJ5 models from other years and the CJ7 are not covered by this boot. Confirm your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.














